Tata Indica - V2 - Electromanuals.org
Tata Indica - V2 - Electromanuals.org
Tata Indica - V2 - Electromanuals.org
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
KNOW YOUR INDICA LPG Do’s & Dont’s<br />
DO’S<br />
• Always get the car repaired/serviced at the Authorised<br />
TATA Service center only.<br />
• Never carry out any repair work on your own or from<br />
any other personnel other than from Authorised TATA<br />
Service center.<br />
• Check LPG fuel system periodically for leakages<br />
Even though the Safety Solenoid valve (on tank &<br />
pressure regulator) closes automatically when you switch<br />
off Ignition, it is recommended to close the manual<br />
service valves during any service/repair activity on the<br />
car.<br />
• Ensure adequate ventilation around the car during repair<br />
works.<br />
• Ensure the LPG in the pipe lines is consumed by running<br />
the engine with closed manual service valves before any<br />
repair work on the gas lines/joints.<br />
• Remove the LPG tank during the welding/brazing work<br />
on the Car.<br />
• Fast toggling of fuel mode LED’s on the Fuel Selector<br />
Switch means fault in the LPG system, please get the<br />
car repaired at the nearest Authorised TATA Service<br />
center.<br />
• Immediately repair/replace any damaged fuel or system<br />
component.<br />
• Use the fire extinguishers provided with the car in case<br />
of unlikely event of fire. These are provided, one near<br />
driver seat and the other one in the boot. Read<br />
instructions on Fire extinguisher to know how to use it.<br />
DON’TS<br />
• Over filling the LPG Tank can cause safety issues<br />
like gas leakage . Please DONOT over fill the tank<br />
beyond its capacity of 31 litres.<br />
• Keep the car away from any Fire source.<br />
• Never use naked flame/fire to check gas leakages.<br />
• Never carry out any welding/brazing on the LPG tanks.<br />
• Avoid direct contact with LPG as it may cause frost<br />
burns.<br />
• Wash instructions - Do not direct high pressure washer<br />
fluid/water jets at electrical devices & their connectors<br />
during washing. This is to prevent malfunction / failure<br />
of electrical system due to water ingress.<br />
• Do not tamper any electrical or mechanical settings.<br />
• Do not scrap / gas cut the LPG cylinder as it contains<br />
pressurised gas which is flamable.<br />
• Do not leave the LPG tank cover open.<br />
For any clarifications please contact the Authorised<br />
TATA Service center<br />
28