Sumo Armoured LBPV - Tata Motors Customer Care
Sumo Armoured LBPV - Tata Motors Customer Care
Sumo Armoured LBPV - Tata Motors Customer Care
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Vehicle Maintenance<br />
Preservation & De-preservation<br />
4 Levels like radiator coolant, engine oil, Gear box oil, axle oil, power steering oil etc…<br />
5 Condition of tyre. (Any depletion happens).<br />
6 Fuel tank condition (inside/Outside).<br />
RETRIVING PRESERVED VEHICLE:<br />
1 Check battery condition & electrolyte level. Check for battery serviceability and if it is in serviceable condition,<br />
send it for servicing.<br />
2 Remove air filter element & clean it.<br />
3 Check water separator. If water level indicator is showing high level then empty the water separator.<br />
4 Remove fuel filters for inspection and if dirty clean it, also clean the entire fuel line. This will ensure removal of<br />
any blockages / water particles / any rusted chip if present inside.<br />
5 If any contamination is observed in levels of engine oil, coolant, gear box oil, power steering oil, rear axle oil<br />
etc... Than then flush the entire contaminated level. After flushing refill oil or coolant.<br />
6 Clean the rusted surface where traces of corrosion are observed. Traces may be observed at electrical<br />
connections like fuse/Starter motor/alternator/connectors/ relays/ etc… These traces required to be cleaned to<br />
ensure proper voltage supply throughout the circuit.<br />
7 Remove all brake drums/ Pads and clean the rusted surface where traces of corrosion are observed. Before<br />
fitting back ensure for no moisture content within system.<br />
8 Do hand priming of fuel line & ensure that fuel is supplied up to injectors, fuel lines and its solenoid for free<br />
movement and free working.<br />
9 Connect properly charged battery to vehicle and crank the engine for 5 seconds to know about any abnormality<br />
in engine noise after cranking. Repeat cranking for 2/3 times to ensure further cranking can be done. Than<br />
crank the engine till it get started. (Do not crank engine for more than 20 sec, because battery cable may be<br />
heated and can cause fire )<br />
78