Brian Kinwald XXX BK2 - Team Losi Racing

Step D-10
BAG D (Continued)
Bearing to Left Gearbox Half:
27 95
q 1. Insert a 3/16" x 3/8" sealed Bearing (27) into the top Bearing seat
of the left Gearbox Half (94).
q 2. Insert a 1/2" x 3/4" Bearing (95) into the lower Bearing seat of
the left Gearbox Half.
*NOTE: If the 1/2" x 3/4" Bearing only has one Teflon seal
(colored, woven looking) in it, position the seal to the outside of the
Gearbox Half.
27
IMPORTANT NOTE: Never allow the Gearbox Halves to come
into direct contact with any type of motor spray/cleaner. The material
used on these parts was selected with performance in mind, and some
motor sprays/cleaners may damage the parts.
94
95
Figure 36
Step D-11
Motor Plate to Right Gearbox Half:
96
27 57
95 98
*Note: Motorplate supplied in kit may look slightly different
than pictured in Figure 37.
q 1. Place the Motor Plate (96) against the outside of the right
Gearbox Half (97) by aligning the hole in the Motor Plate with the
Top Shaft Bearing housing in the right Gearbox Half as shown in
Figure 37.
q 2. Rotate the Motor Plate so that the Screw holes in the Motor
Plate line up with the Screw holes in the Gearbox Half. Secure the
Motor Plate to the Gearbox Half by threading a 4-40 x 1/2" Cap Head
Screw (57) through the hole near the center of the Gearbox Half from
the inside into the hole in the Motor Plate and tighten.
q 3.Insert a 3/16" x 3/8"sealed Bearing (27) into the top
Bearing seat of the right Gearbox Half. Carefully push the Bearing all
the way into the Bearing seat using a pencil or the handle of a hobby
knife. Care should be taken not to damage the seals on the Bearing.
*NOTE: If the 3/16" x 3/8" Sealed Bearing only has one Teflon
seal (colored, woven looking) in it, position the seal to the outside
of the gearbox half.
q 4. Insert a 1/2" x 3/4" sealed Bearing (95) into the lower
bearing seat of the right Gearbox Half.
q 5. Press or lightly tap the Idler Gear Shaft (98), into the hole in the
center of the right Gearbox Half.
16
Figure 37
57
97
95
98
27