Brian Kinwald XXX BK2 - Team Losi Racing

BAG G (Continued)
Step G-7
Rear Body Mount Install:
Figure 60A
54
151
54
q 1. Insert a 4-40 x 3/8" Flat Head Screw (54) into each of the two
rear Body Mounts (151) from the side with the recess for the head of
the Screw.
q 2. Attach a rear Body Mount to the rear of each side of the
Chassis (19) so that the Posts point, at an angle, towards the rear of
the car as shown in Figure 60A. Secure the Body Mounts by tightening
the Screws.
q 3. Apply the Self Adhesive Battery Insulation Tape (121) to both
inner edges of the battery compartment on the Chassis, as shown in
Fig. 60B.
121
19
19
Figure 60B
Step G-8
Battery Foam/Strap Install:
153
155
154
q 1.Place the Battery Spacing Foam (152) into the
recessed area in the rear of the Chassis (19). The foam should be
positioned against the rear Shock Tower (55).
IMPORTANT NOTE: The Battery Strap can be mounted in one
of two ways. The different offset will accommodate different styles of
batteries. If you will be running matched-type cells, or individual cells
laid out side-by-side, the Foam Strip should be attached on the side
with ribs. The foam should be positioned between these ribs. If, however,
you are using a pre-assembled stick pack, the foam strip should
be attached to the side of the strap opposite the ribs.
q 2. Remove the Backing Tape from the Battery Strap Foam Strip
(153) and attach it to the bottom side of the Battery Hold Down Strap
(154).
q 3. Once the battery pack (not included) is installed, the Battery
Strap (154) will hold the batteries in place. The Battery Strap fits
under the rear "bridge" of the Chassis, between the two ribs on the
bottom, and fits over the post on the front Chassis Brace (147). The
strap is secured to the post with a Body Clip (155).
55
152
19
Figure 61
28