Brian Kinwald XXX BK2 - Team Losi Racing

Step E-1
Shock Cartridge Assembly:
BAG E
113 115
116
*NOTE: THIS STEP WILL ONLY BE USED FOR CAR-
TRIDGE MAINTENANCE , ALL CARTRIDGES IN THIS KIT
HAVE BEEN PRE-ASSEMBLED AT THE FACTORY.
113
115
q 1. Place one Shock O-ring (113) into the Cartridge Body (114),
making sure that the O-ring sits flat in the bottom of the Cartridge
Body.
q 2. Insert the Cartridge Spacer (115) into the Cartridge Body followed
by a second O-ring.
q 3. Once the second O-ring is inserted, it should be flush with the
top of the Cartridge Body, press the Cartridge Cap (116) onto the
Cartridge Body. Make sure the Cartridge Cap is snapped all the way
on.
q 4. Repeat assembly process for the remaining three cartridges.
114
Figure 43
Step E-2
Shock Shaft Install:
118 119
q 1. Place a drop of Shock Fluid (117) on the grooved end of each
Shock Shaft [front (118), rear (119)]. Then slide a Cartridge, hex end
first, down the Shock Shaft toward the threads as shown in Figure 44.
118 119
Figure 44
20