Volume II (pdf) - Milestone Construction Services, Inc

1.4 DEFINITIONS
MSSP - Manufacturers Standards Society of the Valve and Fittings Industry
NEC - National Electrical Code
NEMA - National Electrical Manufacturers Association
NFPA - National Fire Protection Association
OSHA - Occupational Safety and Health Administration
TEMA - Tubular Exchanger Manufacturers Association
UL - Underwriters' Laboratories
A. Products: Items purchased for incorporating into the Work, whether purchased for Project
or taken from previously purchased stock. The term product includes the terms material,
equipment, system, and terms of similar intent.
B. Substitutions: Changes proposed by Contractor in products, materials, equipment, and
methods of construction required by the Contract Documents.
1.5 SYSTEM DESCRIPTION
A. Design Requirements: Contract drawings are generally diagrammatic and do not indicate
all offsets, fittings, transitions, access panels and other specialties required.
1.6 SUBMITTALS
1. Furnish and install all items as may be required to fit the work to the conditions
encountered.
2. Arrange piping, equipment and other work generally as shown on the contract
drawings, providing proper clearances and access.
3. Where departures are proposed because of field conditions or other causes,
prepare and submit detailed shop drawing submittal for approval in accordance
with Submittals specified below.
4. Subject to the provisions of Division 1, Architect may make reasonable changes
in location of equipment piping up to the time of rough-in or fabrication.
A. Comply with Section "Submittal Procedures."
B. Shop Drawings and Product Data:
1. Clearly identify all submittals:
a. Indicate intended application, location, etc.
b. Each submittal shall indicate the associated specification section, and
paragraphs. Do not combine product data and shop drawing submittals
from different spec sections into a single submittal package, even though
they may be the same distributor, vendor or part of a single material
order.
c. Clearly indicate the exact type, model number, size and special features
of the proposed item.
d. Include catalog spec sheets to completely describe proposed equipment.
e. Factory order forms only showing the required capacities are not
acceptable.
f. Identify all options furnished to meet specifications.
g. If product is within system supplying fixture intended to dispense potable
water for human consumption, including drinking and cooling, submittals
shall indicate that product is “lead free”, containing not more than a
weighted average of 0.25% lead with respect to the wetted surfaces.
h. Solder and flux for soldered joints in potable water piping shall be “lead
EASTERN DISTRICT POLICE STATION 15050- 2 COMMON WORK RESULTS FOR PLUMBING
28103.01 January 15, 2013