Volume II (pdf) - Milestone Construction Services, Inc

3. Remove and replace Work not conforming to requirements of the Contract
Documents.
4. Remove samples of installed Work as specified for testing.
5. Install equipment and materials in existing structures.
6. Upon written instructions from the Architect, uncover and restore Work to provide
for Architect observation of concealed Work.
C. Cut, remove and legally dispose of selected mechanical equipment, components, and
materials as indicated, including but not limited to removal of mechanical piping, heating
units, plumbing fixtures and trim, and other mechanical items made obsolete by the new
Work.
D. Protect the structure, furnishings, finishes, and adjacent materials not indicated or
scheduled to be removed.
E. Provide and maintain temporary partitions or dust barriers adequate to prevent the spread
of dust and dirt to adjacent areas.
F. Patch finished surfaces and building components using new materials specified for the
original installation and using experienced Installers. Installers' qualifications refer to the
materials and methods required for the surface and building components being patched.
3.4 PAINTING AND FINISHING
A. Refer to Section "Interior Painting” for field painting requirements.
B. Damage and Touch Up: Repair marred and damaged factory-painted finishes with
materials and procedures to match original factory finish.
C. Do not paint manufacturer's labels or tags.
3.5 PENETRATION OF WATERPROOF CONSTRUCTION
A. Coordinate the work to minimize penetration of waterproof construction, including roofs,
exterior walls and interior waterproof construction.
B. Furnish and install drains, curbs, vent assemblies, sleeves, flashing, etc. specifically
designed for application to the particular construction. Install system in accordance with
the roofing manufacturer's instructions.
3.6 EXCAVATION AND BACKFILLING
A. General
3.7 CLEANING
1. Perform all necessary excavation, for installation of work under Division 15, in
accordance with Division 2.
A. Clean surfaces prior to application of insulation, adhesives, coating, and paint.
B. Provide factory applied finish where specified.
C. Protect all finishes, and restore all finishes to their original condition if damaged as a
result of work under Division 15.
EASTERN DISTRICT POLICE STATION 15050- 10 COMMON WORK RESULTS FOR PLUMBING
28103.01 January 15, 2013