Volume II (pdf) - Milestone Construction Services, Inc

access are concealed behind finished surfaces.
H. Coordinate installation of identifying devices after completing covering and painting where
devices are applied to surfaces. Install identifying devices prior to installing acoustical
ceilings and similar concealment.
1.9 DISCREPANCIES
A. Where discrepancies occur between the drawings and specifications or within either
document itself, the item or arrangement of better quality, greater quantity or higher cost
shall be included in the contract price. The Architect shall decide on the item and manner
in which the work shall be provided, based on the design intent of the documents.
1.10 ELECTRONIC CAD DOCUMENTS
A. Requests for electronic CAD documents will be accommodated to the contractors and
installers upon their completion of Kibart’s electronic document release of liability form
and payment for time and expense for document preparation.
1. Kibart’s document preparation fee is as follows:
a. Two hundred and fifty dollars ($250.00) for the first five (5) drawings.
b. Fifty dollars ($50.00) for each drawing thereafter.
PART 2
PRODUCTS
2.1 PRODUCT SELECTION
A. General Product Requirements: Provide products that comply with Contract Documents
that are undamaged and new at time of installation.
1. Provide products complete with accessories, trim, finish, safety guards, and other
devices and details needed for complete installation and intended use and effect.
2. Standard Products: Where available, provide standard products of types that
have been produced and used successfully in similar situations on other projects.
3. Where products are accompanied by the term as selected, Architect will make
selection.
4. Where products are accompanied by the term match sample, sample to be
matched is Architect's.
5. Descriptive, performance, and reference standard requirements in the
Specifications establish salient characteristics of products.
B. General Compliance Requirements: Compliance requirements for individual products, as
indicated in Contract Documents, are multiple in nature and may include generic
descriptions, performance requirements, compliance with reference standards,
conformance with graphic details and other similar forms and methods of indicating
requirements, all of which must be complied with.
C. Procedures for Selecting Products: Contractor's options for selecting products are limited
by Contract Document requirements, and are not controlled by industry traditions or
procedures experienced by Contractor on previous construction projects.
D. Products specified by Reference Standards, Codes and Regulations: Select from among
products, which can be shown to comply with referenced documents.
EASTERN DISTRICT POLICE STATION 15051 - 6 COMMON WORK RESULTS FOR HVAC
28103.01 January 15, 2013