iSTAR eX Installation and Configuration Guide - Tyco Security ...

More documents

Recommendations

Info

iSTAR eX General Controller Module (GCM) GCM Component Layout Figure 1.3 shows the layout of the iSTAR eX GCM. Diagnostic Cable Port 16 General Purpose Inputs 4 Direct Wiegand Reader Ports 4 Relay Outputs 4 Open Collector Outputs Figure 1.4: iSTAR eX GCM Photo 1–10 iSTAR eX Installation and Configuration Guide
iSTAR eX General Controller Module (GCM) iSTAR eX GCM Component Description The iSTAR eX GCM contains these components: • Four Wiegand direct connect reader ports (5V or 12V) • 16 general purpose inputs • Tamper, unsupervised input • Four relay outputs • Four open collector outputs • Two RS-485 serial ports for communicating with readers, inputs, and output modules • Two Ethernet ports, both of which are 10/100Base-T dual sensing (The second Ethernet port can be used for redundant communication with the host, master, or member.) • One USB port. • 400 MHz PXA255 Microprocessor, a member of the Intel XScale family of ARM processors • 64 Mb RAM, for use by programs and as run-time database storage • 32 Mb Flash for the main firmware image and a small “known-good” backup image • 256+ Mb Compact Flash card for database backup (shipped with iSTAR eX). Redundant backups of configuration data • LCD for state and diagnostic display • LEDs for each output, for Ethernet and serial COMM, and for a board “heart-beat” • Coin-cell lithium battery to keep the “Real Time Clock” alive in the absence of AC power or battery power for up to six days • 16 position rotary switch to inhibit or allow ICU, control diagnostics that display on the LCD, clear memory and restore factory defaults • Reset button to force a hardware reboot that erases RAM but does not cause loss of flashed configuration parameters such as IP addresses— unless you select “restore factory default” on the rotary switch at the same time you press the reset button. iSTAR eX Installation and Configuration Guide 1–11
Page 1 and 2: iSTAR eX Installation and Configura
Page 3 and 4: Table of Contents Preface How to Us
Page 5 and 6: Power-On LED Indicator . . . . . .
Page 7 and 8: Primary and Secondary Connections .
Page 9 and 10: Generate Certificates . . . . . . .
Page 11 and 12: ICU Block Feature . . . . . . . . .
Page 13 and 14: Table of Contents Appendix C Append
Page 15 and 16: Preface The iSTAR eX Installation a
Page 17 and 18: Preface Conventions This manual use
Page 19 and 20: Preface FCC Class B Notes When usin
Page 21 and 22: Preface Power Supply Information Mo
Page 23 and 24: 1 Introducing iSTAR eX iSTAR eX is
Page 25 and 26: iSTAR eX Features When configuring
Page 27 and 28: iSTAR eX Features System Components
Page 29 and 30: iSTAR eX Features Figure 1-2 illust
Page 31: iSTAR eX General Controller Module
Page 35 and 36: Power Management Board (PMB) Power
Page 37 and 38: Power Management Board (PMB) PMB Co
Page 39 and 40: Power Management Board (PMB) iSTAR
Page 41 and 42: Power Management Board (PMB) PMB -
Page 43 and 44: iSTAR eX Capacities NOTE The two ou
Page 45 and 46: iSTAR eX Connections iSTAR eX Conne
Page 47 and 48: iSTAR eX Tools iSTAR eX Tools The f
Page 49 and 50: iSTAR eX Tools Power System The Pow
Page 51 and 52: iSTAR eX Tools Power-On LED Indicat
Page 53 and 54: Backup and Restore Backup and Resto
Page 55 and 56: Backup and Restore • Low Battery
Page 57 and 58: Backup and Restore iSTAR eX detects
Page 59 and 60: Backup and Restore Backup Restore P
Page 61 and 62: 2 iSTAR eX Topology This chapter pr
Page 63 and 64: iSTAR eX Network Topology iSTAR eX
Page 65 and 66: iSTAR eX Network Topology Using Net
Page 67 and 68: Single Master and Alternate Master
Page 69 and 70: Single Master and Alternate Master
Page 71 and 72: Maintaining Cluster Communication M
Page 73 and 74: Maintaining Cluster Communication C
Page 75 and 76: Configuring Communication Paths Con
Page 77 and 78: 3 Site Requirements This chapter pr
Page 79 and 80: Pre-Installation Planning Voltage R
Page 81 and 82: Installation Requirements Power Req
Page 83 and 84:
Installation Requirements iSTAR eX
Page 85 and 86:
Installation Requirements Third Par
Page 87 and 88:
Installation Requirements Table 3.8
Page 89 and 90:
4 Hardware Installation This chapte
Page 91 and 92:
Mounting the Enclosure Mounting the
Page 93 and 94:
Mounting the Enclosure To mount the
Page 95 and 96:
Connecting to the Host Connecting t
Page 97 and 98:
Connecting to the Host Low Battery,
Page 99 and 100:
Connecting to the Host To configure
Page 101 and 102:
Connecting AC Power to UL Recognize
Page 103 and 104:
Connecting AC Power to UL Recognize
Page 105 and 106:
iSTAR eX Connections iSTAR eX Conne
Page 107 and 108:
iSTAR eX Connections The connection
Page 109 and 110:
iSTAR eX Connections Wiring RM Devi
Page 111 and 112:
Wiring Inputs and Outputs to the GC
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
LED Connections LED Connections LED
Page 119 and 120:
LED Connections 1 Wire (Yellow) Wit
Page 121 and 122:
LED Connections One Wire ABC LED Co
Page 123 and 124:
LED Connections The two outputs are
Page 125 and 126:
iSTAR eX - Support for 8 Readers Fi
Page 127 and 128:
iSTAR eX - Support for 8 Readers 4.
Page 129 and 130:
iSTAR eX - Support for 8 Readers Mo
Page 131 and 132:
iSTAR eX - Support for 8 Readers 3.
Page 133 and 134:
iSTAR eX - Support for 8 Readers iS
Page 135 and 136:
5 iSTAR eX Encryption This chapter
Page 137 and 138:
Terms, Definitions, and Acronyms Di
Page 139 and 140:
Terms, Definitions, and Acronyms pr
Page 141 and 142:
iSTAR eX Encryption Overview iSTAR
Page 143 and 144:
Key Management Modes Key Management
Page 145 and 146:
Key Management Modes Key Management
Page 147 and 148:
Key Management Modes 4. The key is
Page 149 and 150:
Software Configuration C•CURE 800
Page 151 and 152:
Software Configuration Monitoring P
Page 153 and 154:
Software Configuration You add this
Page 155 and 156:
Creating Certificates Generate Cert
Page 157 and 158:
Creating Certificates • Generate
Page 159 and 160:
Creating Certificates Field descrip
Page 161 and 162:
Creating Certificates Controller Ce
Page 163 and 164:
Creating Certificates • Certifica
Page 165 and 166:
Creating Certificates Export contro
Page 167 and 168:
Creating Certificates • Secondary
Page 169 and 170:
Creating Certificates The default c
Page 171 and 172:
Key Management Policy Key Managemen
Page 173 and 174:
Key Management Policy Signed Certif
Page 175 and 176:
Key Management Policy Figure 5.20:
Page 177 and 178:
Key Management Policy 1. After comp
Page 179 and 180:
Creating Clusters Creating Clusters
Page 181 and 182:
Creating Clusters Figure 5.25: Clus
Page 183 and 184:
C•CURE 800/8000 Reports C•CURE
Page 185 and 186:
C•CURE 800/8000 Reports Figure 5.
Page 187 and 188:
C•CURE 800/8000 Reports Journal R
Page 189 and 190:
Monitoring Station Details for Sele
Page 191 and 192:
Monitoring Station If the key manag
Page 193 and 194:
Monitoring Station If the database
Page 195 and 196:
Monitoring Station • You must gen
Page 197 and 198:
Monitoring Station Figure 5.39: Upd
Page 199 and 200:
Monitoring Station Figure 5.42: Pen
Page 201 and 202:
ICU Certificate Signing and Restore
Page 203 and 204:
Task Lists Task Lists This section
Page 205 and 206:
Task Lists 3. On the Monitoring sta
Page 207 and 208:
Task Lists A. Select ALL controller
Page 209 and 210:
Task Lists 14. All communicating co
Page 211 and 212:
Task Lists Using Certificates Gener
Page 213 and 214:
Task Lists Turning off Custom Certi
Page 215 and 216:
6 Using the iSTAR Configuration Uti
Page 217 and 218:
Overview Configuring a Master Contr
Page 219 and 220:
General Configuration Procedure •
Page 221 and 222:
General Configuration Procedure •
Page 223 and 224:
Understanding the ICU Understanding
Page 225 and 226:
Starting the ICU Starting the ICU T
Page 227 and 228:
Refreshing Controller Information R
Page 229 and 230:
Setting ICU Options Changing the IC
Page 231 and 232:
Using the ICU Window Table 6.2: Too
Page 233 and 234:
Using the ICU Window Table 6.3: ICU
Page 235 and 236:
Using the ICU Window Menu Bar The M
Page 237 and 238:
Configuring a Controller If a contr
Page 239 and 240:
Configuring a Controller Table 6.6:
Page 241 and 242:
Configuring a Controller Table 6.7:
Page 243 and 244:
Configuring SNMP Configuring SNMP O
Page 245 and 246:
Configuring SNMP Figure 6.10: SNMP
Page 247 and 248:
Digital Certificate Signing and Res
Page 249 and 250:
Connecting to the iSTAR Web Page Di
Page 251 and 252:
Connecting to the iSTAR Web Page Di
Page 253 and 254:
Sending Messages to Other ICU Users
Page 255 and 256:
Downloading Firmware Updates The Pr
Page 257 and 258:
7 iSTAR Web Page Diagnostic Utility
Page 259 and 260:
Navigating the Diagnostic Utility N
Page 261 and 262:
Viewing the Status Screen Table 7.1
Page 263 and 264:
Viewing the Cluster Information Scr
Page 265 and 266:
Viewing the Object Store Database S
Page 267 and 268:
Diagnostic Screens In addition to I
Page 269 and 270:
Diagnostic Screens To configure a H
Page 271 and 272:
8 Using the LCD Diagnostic Display
Page 273 and 274:
Displaying Status Messages Displayi
Page 275 and 276:
iSTAR eX Diagnostic Tests You can a
Page 277 and 278:
iSTAR eX Diagnostic Tests Table 8.6
Page 279 and 280:
STAR eX Diagnostic Tests Table 8-8:
Page 281 and 282:
A Controls and Indicators This appe
Page 283 and 284:
iSTAR eX GCM Controls and Indicator
Page 285 and 286:
PMB Controls and Indicators PMB Con
Page 287 and 288:
PMB Controls and Indicators 2 Wire
Page 289 and 290:
PMB Controls and Indicators 3 Wire
Page 291 and 292:
PMB Controls and Indicators iSTAR e
Page 293 and 294:
B Part Numbers This appendix contai
Page 295 and 296:
C Maintenance This appendix describ
Page 297 and 298:
D iSTAR eX Wire Routing Diagrams Th
Page 299 and 300:
iSTAR eX Wire Routing Diagrams
Page 301 and 302:
iSTAR eX Wire Routing Diagrams
Page 303 and 304:
Index Symbols 7-10 Numerics 1 Wire
Page 305 and 306:
Index Communications maintaining 2-
Page 307 and 308:
Index features 1-26 main screen 7-3
Page 309 and 310:
Index Block A-4 Block Feature 6-10
Page 311 and 312:
Index IP address, assigned to maste
Page 313 and 314:
Index Restore Process 1-37 RJ-45 Et
Page 315 and 316:
Index readers 3-11 relay control 3-
show all

iSTAR eX Installation and Configuration Guide - Tyco Security ...

Create successful ePaper yourself

Delete template?

Save as template?