iSTAR eX Installation and Configuration Guide - Tyco Security ...

iSTAR eX Tools
Configuring Controllers
Use the ICU to configure a controller’s IP addresses, connection type, and
identity information.
You can also use the ICU to change a controller’s identity, for example, from
master to member, and to modify a controller’s IP addresses.
At system startup, the C•CURE 800/8000 host downloads IP address
information to the master. To ensure proper configuration, the
information that you enter in the ICU must match the information that
you configure in C•CURE 800/8000.
Viewing Controller Status
If a controller in the ICU’s subnet is powered on, the utility displays the
following information for the controller:
• MAC address
• Name
• IP address
• Parent’s IP address (either the host or master controller IP address)
• Type of controller
• Connection status
iSTAR Web-Based Diagnostic Utility
The Web-based Diagnostic Utility permits using the Web to view iSTAR eX
status and diagnostics information from any networked computer. The iSTAR
web-based diagnostic utility provides:
• Password protection
• Internet access to iSTAR eX controllers
• Diagnostic tools for troubleshooting and monitoring system activity
NOTE
The iSTAR Web-Based Diagnostic Utility has not been evaluated by UL.
1–26 iSTAR eX Installation and Configuration Guide