Untitled - Meijer

. .
WIRING CONNECTIONS
H7: 10-PIN WHITE WIRING HARNESS:
H7/1 BLUE / BLACK Wire (Ignition 3 Output)
This wire provides a 200mA (-) negative ground output that becomes
active 4 seconds before the remote start unit initializes, and remains
grounded while running.
Ignition 3 output:
Some newer vehicles use a
third ignition wire which is
required to start and keep
the vehicle’s engine running.
If this is the case, wire an
IGN 3 relay (not supplied) as
shown: Do not connect
any vehicle circuits together, they
are isolated for a reason.
H7/2 BLACK/VIOLET (Timer Control Channel 6 Programmable
Output)
The BLACK/VIOLET wire provides a 200mA (-) programmable (-)
negative ground output for a variety of optional devices. The output on
the BLACK/VIOLET wire is programmable from 1 to 120 seconds. (See
Alarm Feature #3 Programming Chart.)
This wire can be used to open a sunroof, or any power device you choose
to control. The BLACK/VIOLET wire must be wired to a relay when
powering any devices.
Note: factory default setting is a 1 second momentary (-) negative
ourput. (See Alarm Feature #3 Programming Chart.)
To activate this feature press the transmitter and buttons at the
same time.
H7/3 BROWN/BLACK (Factory Rearm Output)
The BROWN/BLACK wire provides a 200mA (-) negative output for
hooking up to the vehicles factory rearm wire. For factory rearm a (-)
negative pulse is provided after the remote starter times out or is shut
down with the transmitter.
17