BRAVO Install Manual - At Andiron Fireplace Shop
BRAVO Install Manual - At Andiron Fireplace Shop
BRAVO Install Manual - At Andiron Fireplace Shop
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
11 Finishing<br />
A. Mantel Projections<br />
Figure 11.1 shows the minimum vertical and corresponding<br />
maximum horizontal dimensions of appliance mantels or<br />
other combustible projections above the top front edge of<br />
the appliance.<br />
1/2 INCH NON-COMBUSTIBLE<br />
BOARD REQUIRED ON UNIT FACE<br />
1 INCH<br />
MINIMUM<br />
TO<br />
VENT PIPE<br />
Note: All<br />
measurements<br />
in inches.<br />
18<br />
17<br />
16<br />
15<br />
14<br />
13<br />
12<br />
11<br />
10<br />
31/8<br />
9<br />
8<br />
7<br />
6<br />
37/8<br />
5<br />
31<br />
CEILING<br />
91/8<br />
MIN.<br />
FINISHING<br />
EDGE<br />
TRIM<br />
NAILING<br />
TABS<br />
TOP OF<br />
FINISHING STRIP<br />
TOP OF<br />
UNIT<br />
COMBUSTIBLE MATERIALS<br />
MAY CONTACT AND COVER<br />
FRONT AND SIDE AREAS<br />
BELOW GLASS/FRONT<br />
Figure 11.3 Noncombustible Facing Diagram<br />
Figure 11.1<br />
Clearances to Mantels or other Combustibles<br />
above Appliance<br />
WARNING<br />
Figure 11.2<br />
B. Facing Material<br />
Mantel Leg or Wall Projections<br />
(Acceptable on both sides of opening.)<br />
WARNING<br />
Fire Risk.<br />
Do NOT obstruct air inlet or outlet grilles.<br />
Do NOT modify grilles.<br />
• Modifying or covering grilles could cause<br />
temperature rise and fi re hazard.<br />
Finishing materials must not interfere with:<br />
• Air fl ow through grilles or louvers.<br />
• Operation of louvers or doors.<br />
• Access for service.<br />
Risk of Fire<br />
• Non-combustible clearances MUST be<br />
maintained.<br />
• Sheetrock, wood or other combustibles must<br />
NOT be used as sheathing or facing in the<br />
non-combustible zone.<br />
• See Section 11 for proper clearances.<br />
• See Section 1 for combustible/noncombustible<br />
defi nitions.<br />
WARNING<br />
Fire Risk.<br />
Finish all edges and fronts to clearances and<br />
specifi cations listed in manual.<br />
• Black metal appliance front may be covered with<br />
noncombustible material only.<br />
• Do NOT overlap combustible materials onto appliance<br />
front.<br />
• <strong>Install</strong> combustible materials only up to specifi ed clearances<br />
on top, front and side.<br />
• Seal joints between the fi nished wall and appliance top<br />
and sides using only a 300º F minimum sealant.<br />
32<br />
Heat & Glo • Bravo • 704-902 Rev. D • 5/08