Download - Haas Automation, Inc.

MADE IN U.S.A.
HRT 310 Table-to-Fixture Bolt Hole Pattern
Remove Top
Cover to Access
Toe-Clamp Pockets
1/2-13UNC T-Nuts,
Studs, Flange nuts
and Washers*
Bottom of Casting
Clamping Tool
Assembly (2)
1/2-13UNC T-Nuts,
Studs, Flange Nuts,
and Washers*
1/2-13UNC T-Nuts,
Studs, Flange nuts,
and Washers
1/4-20UNC
SHCS (4)
Toe-Clamp
Assembly (2)*
Toe
Clamp
Assembly*
Standard stud mounting, front and rear For extra rigidity, use additional Toe-Clamps (*not supplied)
The HRT 310 can be secured as shown (Dimensions are in inches)
3/4-10UNC
X8” SHCS
(4)
7.875”
1” Req.
Fixture
Plate
HA5C Mounting
0.781”Ø Thru C’Bore
1.188 ØX0.80 DP
1/2-13UNC
T-Nuts,Studs,
Flange nuts
and Washers
5.000
5.000
Mininum
Fixture
7.75
6.075
Plate
Length
10.00
7.500
Fixture Plate to
Mill Table Bolt
Hole Pattern
4.450
4.450
13.500
as Required (Table Width)
by End User
AUTOMATION
1/2-13UNC
Flange Nuts (2)
1/2-13UNC T-Nuts,
Studs, Flange nuts
and Washers
1/2-13UNC
T-nuts (2)
1/2-Inch
Washers (2)
1/2-13UNC
Studs (2)
1. Secure the unit to the mill table.
2. Connect the cables from the rotary unit to the control, with the power off. Never
connect or disconnect the cables with the power on. It can be connected as
either a full-fourth or semi-fourth axis. See the following figure. For full-fourth axis,
the indexer is connected directly to the Haas mill control at the connector labeled “A
axis”. The mill must have the 4th (and 5th) axis option(s) to run full-4th (and full-5th)
axis.
96-0315 Rev P
April 2012
3
Original Instructions