Download - Haas Automation, Inc.

5. Push and hold the Clear button for five seconds. “01 000.000” displayed.
6. Enter 90000
7. Push Mode button. Steady displays.
8. Push Cycle Start to index.
Example #2
Index the platter 90° (Example #1, Steps 1-8), rotate at five degrees/sec (F5) in the
opposite direction for 10.25 degrees, and then return home.
9. Push the Mode button. Displays blinking.
10. Push the Down Arrow once. You should be on Step 2.
11. Enter 91 on the key pad. Use Clear to erase mistakes.
12. Push the Display Scan button once.
13. Enter -10250 on the keypad.
14. Push the Down arrow once. The control is now on the feed display.
15. Enter 5000.
16. Push the down arrow once. The control is now on step 3.
17. Enter 88.
18. Push the up arrow four times. The control is now on step 1.
19. Push the Mode button. The display will become steady (not flashing).
20. Push the Cycle Start button three times. The unit should index 90 degrees
(90°), slow feed in the opposite direction for 10.25 degrees (10.25°), then
return home.
The following examples show the program as you would enter it into the control.
We will assume each time that you have cleared out the memory. The bold-face
type indicates data that to be entered into the controller.
Example #3
Drill a four-hole pattern, and then a five-hole pattern on the same part.
Step Step Size Feed Rate Loop Count G Code
(see previous feed rate table)
01 90.000 270.000 (HA5C) 4 91
02 72.000 270.000 (HA5C) 5 91
03 0 270.000 (HA5C) 1 99
Example #3 could have also been done using Circle Division.
Step Feed Rate Loop Count G Code
(see previous feed rate table)
01 270.000 (HA5C) 4 98
02 270.000 (HA5C) 5 98
03 270.000 (HA5C) 1 99
Example #4
Index 90.12 o , start a seven-hole bolt pattern, and then return to the zero position.
96-0315 Rev P
April 2012
39
Original Instructions