njit-etd2000-029 - New Jersey Institute of Technology

More documents

Recommendations

Info

The Van Houten library has removed some of the personal information and all signatures from the approval page and biographical sketches of theses and dissertations in order to protect the identity of NJIT graduates and faculty.
ABSTRACT SYNTHESIS AND CHARACTERIZATION OF LOW PRESSURE CHEMICALLY VAPOR DEPOSITED BORON NITRIDE AND TITANIUM NITRIDE FILMS by Narahari Ramanuj a This study has investigated the interrelationships governing the growth kinetics, resulting compositions, and properties of boron nitride (B-C-N-H) and titanium nitride (Ti-N-CI) films synthesized by low pressure chemical vapor deposition (LPCVD) using ammonia (NH3)/triethylamine-borane and NH 3/titanium tetrachloride as reactants, respectively. Several analytical methods such as the FTIR, UV/Visible spectroscopy, XPS, AES, RBS, SEM, and XRD were used to study the stoichiometry and structure of the deposited films. The B-N-C-H films were synthesized over a temperature range of 300 to 850°C at various flow rate ratios of the reactants and total pressure range of 50 to 150 mTorr. The deposits were amorphous in all cases having an index of refraction ranging between 1.76 and 2.47 depending on the composition of the films. The stress of the deposited films varied from +240 to —200 MPa, depending on the deposition parameters. The hardness and Young's modulus were found to be between 5 to 12 GPa and 50 to 120 GPa, respectively. Electrical properties of the BN films were measured using metal-insulator-metal (MIM) and metal-insulator-semiconductor (MIS) structures. The films did not react with water vapor and exhibited dielectric constant between 3.12 and 5.5. Free standing X-ray windows with thickness varying from 2000A to 12,000A, were fabricated using the mildly tensile and compressive films and X-ray transmission studies through these windows
Page 1: Copyright Warning & Restrictions Th
Page 5 and 6: SYNTHESIS AND CHARACTERIZATION OF L
Page 7 and 8: APPROVAL PAGE SYNTHESIS AND CHARACT
Page 9 and 10: This thesis is dedicated to my pare
Page 11 and 12: TABLE OF CONTENTS Chapter Page 1 IN
Page 13 and 14: TABLE OF CONTENTS (Continued) 2.6 A
Page 15 and 16: TABLE OF CONTENTS (Continued) Chapt
Page 17 and 18: LIST OF TABLES Table Page 1.1 Evapo
Page 19 and 20: LIST OF FIGURES (Continued) 4.2 Fil
Page 21 and 22: LIST OF FIGURES (Continued) 4.43 SE
Page 23 and 24: 2 of transistors on a chip would co
Page 25 and 26: 4 Typically, light beams do the etc
Page 27 and 28: Having the technology to transfer t
Page 29 and 30: 8 capacitance of the wire. It may s
Page 31 and 32: 10 side of the chip to the other. O
Page 33 and 34: metal/oxide/semiconductor integrate
Page 35 and 36: 14 properties of the film obtained
Page 37 and 38: 16 Chemical vapor deposition is dis
Page 39 and 40: 18 Figure 1.1 Scheme to show the tr
Page 41 and 42: 20 the low-pressure operation. Dry
Page 43 and 44: 22 • Reaction: The surface cataly
Page 45 and 46: 24 If the deposition process is lim
Page 47 and 48: 26 1.2 Types of CVD Process As ment
Page 49 and 50: 28 Lowering the gas pressure by abo
Page 51 and 52: 30 purity and density, controllable
Page 53 and 54:
32 to block alkali ions. All films
Page 55 and 56:
34 Some of the attractive propertie
Page 57 and 58:
36 1.5 Refractory Materials Ceramic
Page 59 and 60:
38 deposited and then a conducting
Page 61 and 62:
40 Table 1.7 Physical properties of
Page 63 and 64:
42 In Chapter 2, a review of litera
Page 65 and 66:
Material Melting Temperature (°C)
Page 67 and 68:
46 The reaction involving BCl 3 for
Page 69 and 70:
48 B2H6 + 2NH3 = 2BN + 6H2 Rand et
Page 71 and 72:
50 ammonia at 250° - 600°C in an
Page 73 and 74:
52 2.3.1 Synthesis by CVD and LPCVD
Page 75 and 76:
54 temperature range of 700-1300 K
Page 77 and 78:
56 The refractive index of c-BN was
Page 79 and 80:
58 the problem to hydrogen content
Page 81 and 82:
60 Many researchers 70,69,82 have s
Page 83 and 84:
62 BN film coatings are useful to i
Page 85 and 86:
64 2.5.1 Dielectric Thin Films With
Page 87 and 88:
66 A family of thermally stable, lo
Page 89 and 90:
68 suggested that the there is a ch
Page 91 and 92:
70 a heavily dependent on process c
Page 93 and 94:
72 Typically thin beryllium or poly
Page 95 and 96:
Figure 2.2 Trends in ULSI miniaturi
Page 97 and 98:
76 Figure 2.3 Basic SCALPEL princip
Page 99 and 100:
78 50 nanometers and smaller. The r
Page 101 and 102:
80 A large number of materials have
Page 103 and 104:
82 2.7 Aim and Scope of the Present
Page 105 and 106:
84 jacket maintained the temperatur
Page 107 and 108:
86 Figure 3.2 Schematic diagram of
Page 109 and 110:
88 contamination and hence requires
Page 111 and 112:
90 known reaction chamber volume. T
Page 113 and 114:
92 all the experiments. The boat wa
Page 115 and 116:
94 limited by sample surface and a
Page 117 and 118:
96 3.5.6 Film Stress Stress develop
Page 119 and 120:
98 3.5.7 X-Ray Diffraction (XRD) A
Page 121 and 122:
100 where hγ , Eg(opt) and K 1 den
Page 123 and 124:
102 technique. However the films we
Page 125 and 126:
104 same film surface. Such measure
Page 127 and 128:
106 the device, an electrical conta
Page 129 and 130:
108 Figure 3.5 Process flow diagram
Page 131 and 132:
110 samples. The recombination-gene
Page 133 and 134:
112 3.7.2 Characterization of B-N-C
Page 135 and 136:
114 In all the experiments, films d
Page 137 and 138:
116 operating in the mass transfer
Page 139 and 140:
118 variation in the NH3/TEAB flow
Page 141 and 142:
120 mode, and a small peak close to
Page 143 and 144:
122 infrared absorption spectra, no
Page 145 and 146:
124 increasing the NH3/TEAB flow ra
Page 147 and 148:
126 tensile behavior with increase
Page 149 and 150:
128 material with the electrons jum
Page 151 and 152:
130 while at a constant temperature
Page 153 and 154:
132 4.4.6 Electrical Characterizati
Page 155 and 156:
134 4.4.6.2 Investigation of LPCVD
Page 157 and 158:
136 Figure 4.17 C-V curve shift alo
Page 159 and 160:
138 Figure 4.18 Capacitance-Voltage
Page 161 and 162:
140 Thus by knowing the refractive
Page 163 and 164:
142 rate of 40 sccm, as the Power w
Page 165 and 166:
144 4.4.7.2 Characterization of B-N
Page 167 and 168:
146 the reactant species in eq. 4.2
Page 169 and 170:
148 Figure 4.25 Variation of Film C
Page 171 and 172:
150 Figure 4.27 Plot of growth rate
Page 173 and 174:
152 4.5.3 Rate Equation Knowing the
Page 175 and 176:
154 4.5.4 Reaction Mechanism In the
Page 177 and 178:
156 high TiC14 coverage. ΘTiC13 ca
Page 179 and 180:
158 Figure 4.30 shows a typical XPS
Page 181 and 182:
160 degraded. Hence, films with thi
Page 183 and 184:
162 Figure 4.35 Variation in film d
Page 185 and 186:
164 Figure 4.37 Variation in film r
Page 187 and 188:
166 emittance increased; the transm
Page 189 and 190:
Figure 4.41 SEM micrograph of TiN d
Page 191 and 192:
Figure 4.4 3 SEM micrograph of TiN
Page 193 and 194:
172 Orientation (hid) Table 4.1 Com
Page 195 and 196:
174 carried out under the same proc
Page 197 and 198:
176 was not in a compound form. It
Page 199 and 200:
REFERENCES 1. R. Turton. 1995. The
Page 201 and 202:
180 36. W. Kern and V. S. Ban, "Che
Page 203:
182 74. L. Imhoff, A. Bouteville, a
show all

njit-etd2000-029 - New Jersey Institute of Technology

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?