Custom Classics Catalog

MODIFICATIONS
REEVES
Introduction
DODGE APG
MASTER XL
MOTODRIVE
MODIFICATIONS
MOTOR OPTIONS
A variety of Reliance C-face motors are available off the shelf
for use on
MOTODRIVE units. Examples include corrosion resistant (XT),
Easy Clean, high efficiency (XE), and explosion-proof. When
explosion proof motors are used, the torque ratings shown on
the selection charts must be derated by multiplying the output
torque shown by .87. This is because explosion proof motors
are not service factored. Standard MOTODRIVE drivemotors
are 1750 rpm, 3 phase, 230/460 volt, 60 Hz, TEFC, Class F
insulated, Design B, C-face footless, and Reeves Service
Factored.
SPECIAL VARIABLE SHAFT EXTENSIONS
Supplied as a standard NEMA C-face flange and extension on
the bearing plate opposite the reducer. The flange size is the
same as in the flanged output section of this catalog. Can be
used for brake mounting.
TACHOMETERS
The Tachometer pick-up system is a standard magnetic
reluctance pick-up. A 60 tooth gear is mounted on the
variable shaft, which is related to the output shaft speed by
the reducer ratio. A digital readout indicator is included with
a choice of a battery powered LCD display, or a 115 Volt AC
powered LED display. Both displays are fully programmable,
so that the output can be user calibrated to match any output
characteristic. Also included is 10 feet of signal cable with the
Amphenol connector for connection to the magnetic pick-up.
The cable length may be increased by the user up to 500 feet.
Additional indicators may be purchased.
For dimensions refer to page D5-69.
TRUNNION MOUNTING
Trunnion mounting is a reduced foot print mounting system.
The unit mounts on two sets of feet on opposite sides of the
beltcase, instead of the one larger foot print of the normal
mounting. This option is only available on no reducer and
single reduction units. See the Dimensions/Assemblies pages
for future information.
XT-EXTRA TOUGH PACKAGE
For sizes 300-600, this option includes a Reliance XT motor,
Chromalife Discs, sealed bearings, ventilated inspection and
bearings plates.
For sizes 050-200, the beltcase is totally enclosed and
Chromalife Discs are normally not required. If XT features are
requested, a XT motor can be added to the drive.
REEVES ULTIMA
REEVES MOTODRIVE
DODGE Combination TIGER
D5-58