TANDBERG Edge 95-85-75 MXP User Manual (F5).pdf - Expoficina

General Use
5.2.6 Number Key Mode
When pressing a number key on the remote control, while in a call, the user can decide what
shall happen. The system can be configured to act automatic or manual.
While in a call, the user presses a number key to:
• add another call
• dial extension numbers
• use camera presets
Setting Number Key to Automatic:
Some users want the camera presets as the default action when pressing a number key, when in
a call. The number keys can be configured to always act like this; or to act in accordance to any
of the other available choices.
Setting Number Key to Manual:
Sometimes, when you are in a call, you need to switch between adding another call, dial
extension numbers or use camera presets. Then you would want the system to give you a choice
of what to do. If you configure the Number Key Mode to Manual you can select the preferred
action when pressing a number key.
The Number Key Mode are available from Menu Settings and the default setting is Manual. See
Control Panel – Menu Settings – Number Key Mode.
TIP: You can always press “Touch Tones” on the remote control to enter an extension number,
password or access code while in a call.
The Number Key Mode is set to Manual
133