TANDBERG Edge 95-85-75 MXP User Manual (F5).pdf - Expoficina

Appendices
(Not available with set top systems)
WAVE II Camera
Pinouts and Connectors
8-PIN RJ (shielded modular jack):
This connector is used for the power and control signals to the main camera.
Pin-8 +12V (presence when connected in
daisy chain)
Pin-7 GND
Pin-6 GND
Pin-5 RXD (in)
Pin-4 TXD (out)
Pin-3 +12V
Pin-2 GND
Pin-1 + 12V
Standard Phono:
Used for composite video signal
Power:
2.0 mm DC power jack (+12V, 1A required)
Standard Mini Din:
Used for S-Video signal
6-PIN RJ (modular jack):
This connector is used when cascading cameras: Control (out) signal and external camera
detection. Note: It does not provide power for cascaded camera.
PRI
Pin-6
Pinout
GND
263