TANDBERG Edge 95-85-75 MXP User Manual (F5).pdf - Expoficina

TANDBERG Edge 75/85/95 MXP
2 Audio Outputs
• 1 output (line level) via RCA connector providing audio from far end in addition to dial
tones. This output is used by the monitor. This output also supports S/PDIF.
• 1 VCR output (line level) via RCA connector providing a mixed signal between audio from
the local side (except from the VCR input) and audio from the far end. This output is
intended for connection to a VCR.
Audio output connector specification:
Connector label
Audio outputs
Signal type
Unbalanced
Connector (codec)
Female RCA/phono, sleeve-ground,
centre-signal
Output impedance
680 ohms
Max output level when set 15.5 Vpp
to maximum output level
and volume control set to 1.2 Vpp
max.
Max output level when set
to minimum output level and
volume control set to max.
Range, menu adjustable 22.5 dB (16 steps of 1.5 dB)*
output gain
Volume control attenuation 0 to 21 dB + mute (steps of 1.5 dB)
(audio out 1)
* Additional attenuation is possible on room/loudspeaker audio output using the volume control
setting
224