TANDBERG Edge 95-85-75 MXP User Manual (F5).pdf - Expoficina

TANDBERG Edge 75/85/95 MXP
5) Type in your IP password (default is “TANDBERG”) as password.
6) Type ‘put and press Enter. The new software file will now be
uploaded to the TANDBERG MXP system.
7) When the software upload is complete, end the ftp connection to the TANDBERG MXP
system by typing ‘bye’ in the DOS prompt.
8) To exit the DOS window completely, type ‘exit’
9) Restart the system to activate the new software.
C) ISDN Upgrade
The TANDBERG MXP systems has the possibility to be upgraded remotely from another
TANDBERG MXP system using ISDN. Please note that both systems must be on software
version F3.0 or newer for this functionality.
Please also note that both systems must be on software version F3.0 or newer for this
functionality
1. Connect to the system that shall be upgraded using ISDN
2. Copy the new software file to a folder on your computer, for instance c:\software.
3. Type the IP address of the TANDBERG MXP system that the software upgrade is going to be
done from (for instance 10.0.8.77) in a standard browser, such as Internet Explorer 6.0. The web
interface of the codec will then be displayed.
4. Select the ‘System Configuration’ tab on top of the page, and then the sub-tab ‘Far end
upgrade’.
274