TCP/IP Converter DDS EX-9132 Operation Manual for 8051 Series

More documents

Recommendations

Info

Controller Updated Press “Update” Button After you finish the detailed parameter setting. The converter will save all parameters into internal non-volatile memory and then reboot . It takes about 5 seconds to complete the whole process, and a new login page will be presented . You can re-login and check if all parameters have been correctly saved. If everything is ok, you can close the browser now. Note : If the domain of the converter is different from that of the computer running the browser, the login page won’t appear unless the converter’s “Gateway Address” has been correctly set. 29
Factory Default Setting If by chance, you <strong>for</strong>get the setup password, or have incorrect settings making the converter inoperable, there are two ways to reset the setting and the following procedures can be used to reset all settings to factory default: A: 1. you can turn off the power and then use any point tip to push “Reset” button and hold it to turn on the power at the same time <strong>for</strong> 5 seconds. The password will be reset to the factory default. B: 1. Turn off the power of the converter. 2. Use a pin or any point tip to push the screw driver or any conductor to short DTR and CTS (pin 4 and pin 8 in DB9) of RS232 connector. 3. Turn on the power of the converter and wait 5 seconds. 4. Remove screwed driver or conductor. 30
Page 1 and 2: TCP/IP Converter DDS EX-9132 Operat
Page 3 and 4: Controller Setup ………………
Page 5 and 6: Overview TCP/IP converters are desi
Page 7 and 8: Block Diagram Low-cost devices usua
Page 9 and 10: Product Specifications • CPU : 8-
Page 11 and 12: Converter Description & Installatio
Page 13 and 14: Reset Button If by any chance, you
Page 15 and 16: Wiring Architecture RS-232 Wiring A
Page 17 and 18: 3 Converter Configuration Initial I
Page 19 and 20: Refresh Refresh the status. ExpertD
Page 21 and 22: Web Console Configuration In additi
Page 23 and 24: Field Description □ System time e
Page 25 and 26: □ Field Description □ IP Addres
Page 27 and 28: □ Socket port of Digital I/O □
Page 29: □ Setup password Administration p
Page 33 and 34: Hyper Terminal for TCP/IP WinSock I
Page 35 and 36: After “OK” button is pressed, F
Page 37 and 38: Data Transmission When all steps de
Page 39 and 40: Appendix B Pin outs and Cable Wirin

TCP/IP Converter DDS EX-9132 Operation Manual for 8051 Series

Create successful ePaper yourself

Delete template?

Save as template?