TCP/IP Converter DDS EX-9132 Operation Manual for 8051 Series

More documents

Recommendations

Info

Hyper Terminal for COM Port Initiate another Hyper Terminal as a COM Port Terminal (in Figure 4.3, select COM 1 or other COM port instead of “TCP/IP (Winsock)”). Set the COM port Properties to be the same as those set for the Serial Port of the converter. (Figure 4.3) 35
Data Transmission When all steps described above are finished, type any characters on the COM Port Terminal and check if the typed characters are also displayed on the TCP/IP Winsock Terminal. Alternatively, check if the characters typed on the TCP/IP Winsock Terminal are also displayed on the COM Port Terminal. If yes, then all settings are correct and the converter can operate properly. 36
Page 1 and 2: TCP/IP Converter DDS EX-9132 Operat
Page 3 and 4: Controller Setup ………………
Page 5 and 6: Overview TCP/IP converters are desi
Page 7 and 8: Block Diagram Low-cost devices usua
Page 9 and 10: Product Specifications • CPU : 8-
Page 11 and 12: Converter Description & Installatio
Page 13 and 14: Reset Button If by any chance, you
Page 15 and 16: Wiring Architecture RS-232 Wiring A
Page 17 and 18: 3 Converter Configuration Initial I
Page 19 and 20: Refresh Refresh the status. ExpertD
Page 21 and 22: Web Console Configuration In additi
Page 23 and 24: Field Description □ System time e
Page 25 and 26: □ Field Description □ IP Addres
Page 27 and 28: □ Socket port of Digital I/O □
Page 29 and 30: □ Setup password Administration p
Page 31 and 32: Factory Default Setting If by chanc
Page 33 and 34: Hyper Terminal for TCP/IP WinSock I
Page 35: After “OK” button is pressed, F
Page 39 and 40: Appendix B Pin outs and Cable Wirin

TCP/IP Converter DDS EX-9132 Operation Manual for 8051 Series

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?