TCP/IP Converter DDS EX-9132 Operation Manual for 8051 Series

More documents

Recommendations

Info

Select “TCP/IP(Winsock)” option at the “Connect using:” field (see Figure 4.3) . (Figure 4.3) After “OK” button is pressed, Figure 4.4 appears. Enter the converter’s IP address (e.g. 192.168.0.10) at the “Host address:” field, and the Socket port number set for the Serial Port 1 at the “Port number:” field (e.g 4660). (The Socket type of the Serial Port 1 should be “TCP Server”.) (Figure 4.4) 33
After “OK” button is pressed, Figure 4.5 appears. If the Hyper Terminal connects with the converter successfully, the time clock at the “left lower” corner “Connected hh:mm:ss” will start counting. (Figure 4.5) 34
Page 1 and 2: TCP/IP Converter DDS EX-9132 Operat
Page 3 and 4: Controller Setup ………………
Page 5 and 6: Overview TCP/IP converters are desi
Page 7 and 8: Block Diagram Low-cost devices usua
Page 9 and 10: Product Specifications • CPU : 8-
Page 11 and 12: Converter Description & Installatio
Page 13 and 14: Reset Button If by any chance, you
Page 15 and 16: Wiring Architecture RS-232 Wiring A
Page 17 and 18: 3 Converter Configuration Initial I
Page 19 and 20: Refresh Refresh the status. ExpertD
Page 21 and 22: Web Console Configuration In additi
Page 23 and 24: Field Description □ System time e
Page 25 and 26: □ Field Description □ IP Addres
Page 27 and 28: □ Socket port of Digital I/O □
Page 29 and 30: □ Setup password Administration p
Page 31 and 32: Factory Default Setting If by chanc
Page 33: Hyper Terminal for TCP/IP WinSock I
Page 37 and 38: Data Transmission When all steps de
Page 39 and 40: Appendix B Pin outs and Cable Wirin

TCP/IP Converter DDS EX-9132 Operation Manual for 8051 Series

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?