Installation Manual C15, C20, C25 - Waltco
Installation Manual C15, C20, C25 - Waltco
Installation Manual C15, C20, C25 - Waltco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 4<br />
LIGHT INSTALLATION<br />
Install lights and rubber bumpers (if ordered) using<br />
parts and fasteners provided.<br />
<strong>Installation</strong><br />
Hex Nut<br />
Machine Screw<br />
Taillight Bracket<br />
Dock Bumper Assembly<br />
Harness, 2 lamps<br />
Light grommet<br />
Taillight,<br />
White back-up<br />
Taillight,<br />
Red S, T&T<br />
Rubber Bumper<br />
Hex Nut welded<br />
inside dock bumper<br />
GR02089<br />
<strong>Waltco</strong> offers three suggestions for the installation of the<br />
vehicle taillights. We believe these suggested locations<br />
meet D.O.T. regulations but do not warrant that they do.<br />
Your installation of the vehicle taillights should meet all<br />
applicable regulations and requirements. This is in no<br />
way to infer that these suggestions are the only correct<br />
method of installing taillights.<br />
skin, if there is sufficient room.<br />
the body rear corner posts.<br />
bumpers available that<br />
have lights included as part of the dock bumper.<br />
NOTE:<br />
Original equipment lights may not provide sufficient<br />
clearance at this location so a narrower light may be<br />
required.<br />
All lights must be installed in accordance<br />
with all applicable D.O.T. regulations.<br />
GR02503<br />
Page 28