Installation Manual C15, C20, C25 - Waltco

REMOTE MOUNT BRACKET INSTALLATION INSTRUCTIONS
1. Locate a position for the pump on the truck frame as near to the rear of the vehicle as practical.
Shown below are three possible ways the pump may be mounted.
If the p
80000429) so that a switch can be mounted on the curb side.
Mounted on crossmembers parallel
to the vehicle frame
Mounted on crossmembers
perpendicular to the vehicle frame
Bolted or welded to the vehicle
frame
2. Install Remote Bracket on to the vehicle.
If welding to crossmembers
Weld top ends of Mount Bracket to a
crossmember.
Weld both sides of one end of Brace to a
crossmember.
Weld (3) sides of other end of Brace to the
Mount Bracket.
If bolting Mount Bracket to
vehicle frame
Weld both sides of one end of
Brace to the body long
member.
Weld (3) sides of other end of
Brace to the Mount Bracket.
If welding Mount Bracket to
vehicle frame
Weld the Mount Bracket as
shown
Also weld Brace as shown in
previous picture.
3. Add Gasket
to Mount
Bracket.
4. Detach hoses and unfasten
(4) hex-screws to
remove pump.
5. Replace vented
plug with Square
Head Plug
6. Connect Hose
Extension to Hydraulic
Hose.
7. Fasten Pump to Mount Bracket using the (4) hex
screws.
8. Re-attach hoses.
9. Secure hoses to the vehicle using the hose
clamps and self-tapping screws provided.
Self-tapping Screw
Hose Clamp
IMPORTANT:
Hydraulic hoses are to be
protected from sharp
edges, and never secured
near exhaust system.
80101284 Rev 02 3/16/01
Page 44