Operating Manual Unbalance Motors - AViTEQ Triltechniek

Operating Manual for AViTEQ Unbalance Motors, Series UV...-A_
...........................................................................................................................................................................................................................................................................................................................................................................................................
1.3 Operative Range
AViTEQ unbalance motors are designed and used as single or double drives for
vibration (conveyor) devices for discharging, conveying, feeding, compacting, loosening,
dosing, and/or screening of bulk materials. The unbalance motors are not
intended for any other purposes.
As a three-phase cage motor, the unbalance motor is suited for use with 50 Hz or 60
Hz three-phase mains supplies. Some special unbalance motor types are design-ed
and built for single-phase operation for use with 50 Hz or 60 Hz mains supplies.
NOTE
Operating the unbalance motor with a frequency converter at a three-phase mains
supply is allowed. The allowed frequency range for the output frequency of the
frequency converter is 20 up to 50 Hz with a 50 Hz-mains frequency and 20 up to
60 Hz with a 60 Hz-mains frequency. In case of doubt, please contact us!
Never use in the following cases:
• Do not use with mains voltages and mains frequencies that, according to the
information on the type label, are not adapted for the unbalance motor.
• Do not use in environmental temperatures below -20°C and above +40°C or
+55°C depending on the type, or in tropical climate! The unbalance motors are
designed for operation in moderate climate environments. Special versions for
non-moderate climate environments might be possible on request.
• Do not use at elevations above 1,000 m above sea level without first consulting
AViTEQ Vibrationstechnik GmbH.
• Do not use if an explosive gas atmospheres like a gas-, a vapour-, a mist-airmixture
is existing or for conveying explosives.
1.4 Installation an Operating Personnel
Prior to installation and/or commissioning,
you must be familiar with all details
and connexion configurations of the
unbalance motor.
Persons involved with installation, commissioning, assembly, disassembly, adjustment
or maintenance must have read and understood this operating manual in its
entirety; in particular the safety notes. If you have any questions, we would be glad
to help you!
NOTE
Please observe the following remarks, if the unbalance motor is operated in areas
with the presence of combustible dust:
• The selection of the drives and the installation of the units must be carried out by
accordingly trained and qualified personnel in compliance with EN 61241-14.
• The inspection and maintenance of the drives must be carried out by accordingly
trained and qualified personnel in compliance with EN 61241-17.
• Repair and overhaul of the drives, as far as allowed, must be carried out by
accordingly trained and qualified personnel in compliance with IEC 61241-19.
The unbalance motors are only allowed to be repaired by AViTEQ
Vibrationstechnik GmbH or by special trained and authorised service personnel.
AViTEQ Vibrationstechnik GmbH is not liable for damage to property and/or
persons in the case of neglect!
All work on the electrical installation must only be carried out by qualified personnel
(electricians or persons trained in electrical engineering according to EN 60204-1).
...........................................................................................................................................................................................................................................................................................................................................................................................
© 2009 AViTEQ Vibrationstechnik GmbH Version 04/2009 13 / 48