Operating Manual Unbalance Motors - AViTEQ Triltechniek
Operating Manual Unbalance Motors - AViTEQ Triltechniek
Operating Manual Unbalance Motors - AViTEQ Triltechniek
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
...........................................................................................................................................................................................................................................................................................................................................................................................................<br />
NOTE<br />
Only use mounting screws/bolts with a bolt quality of at least 8.8!<br />
The mounting surface for the unbalance motor must be absolutely even to prevent<br />
the feet of the unbalance motor from cracks and breakings! Please observe this!<br />
4 Screw the unbalance together with the vibration (conveyor) device. Tighten the<br />
mounting screws with the torque indicated in table 4.1.<br />
Screw size<br />
Tightening torques<br />
(Bolt quality 8.8)<br />
Table 4.1<br />
[Nm]<br />
M 5 5,9<br />
M 8 25<br />
M10 49<br />
M12 85<br />
M16 210<br />
M24 730<br />
M27 1100<br />
M30 1450<br />
M36 2360<br />
M42 3800<br />
Screw tightening torques<br />
NOTE<br />
According to the recommendation shown in chapter 6.1, please check if there is a<br />
reduction of the screw tightening torque caused by subsidence and retighten the<br />
screws if required to avoid the unbalance motors from becoming loose!<br />
5 In the case of through holes, each nut must be secured by a locknut. If it is not<br />
possible to use such a locknut, the nut must be secured using Loctite, just as in<br />
the case of threaded holes.<br />
foot of the motor<br />
mounting surface<br />
(clean, free of oil, and<br />
paint residue)<br />
liquid locking<br />
nut<br />
locknut<br />
6 Alternative: Depending on the vibration (conveyor) device it is possible to use<br />
stud bolts and locknuts (...on the unbalance motor’s side, as on the photo to the<br />
left).<br />
...........................................................................................................................................................................................................................................................................................................................................................................................<br />
26 / 48
Change language