Download - ADInstruments

More documents

Recommendations

Info

Units Click Units… to display the Units Conversion dialog, with which you can set the units for a channel and, using waveform measurements, calibrate the channel. The waveform in the data display area of the GP Amp dialog is transferred to the data display area of the Units Conversion dialog. (Use the Pause button to capture a specific signal.) The units conversion only applies to subsequently recorded signals, so it is more limited than choosing Units Conversion… from the Channel Function pop-up menu, as it does not allow conversion of individual blocks of data. 30 GP Amp Owner’s Guide
3 Adapting Transducers This chapter looks in detail at the modifications that may be required to connect third-party transducers to the GP Amp. Transducers supplied by <strong>ADInstruments</strong> should connect directly with no problems, so if you are using them, you probably won’t need to read the chapter. If you are using third-party transducers with your GP Amp, or have some half-bridge transducers you want to use with it, you may need to adapt them and that information is provided here. Chapter 3 Adapting Transducers 31
Page 1 and 2: GP Amp Owner’s Guide
Page 3 and 4: Contents Safety Notes 5 1 Overview
Page 5 and 6: Safety Notes Statement of Intended
Page 7 and 8: • All Bio Amp front-ends (except
Page 9 and 10: PowerLab systems (and many other de
Page 11 and 12: Your PowerLab system can be periodi
Page 13 and 14: Overview The GP Amp is one of a fam
Page 15 and 16: The PowerLab controls front-ends th
Page 17 and 18: I 2 C Input and Output Sockets Two
Page 19 and 20: How Transducers Work The GP Amp can
Page 21 and 22: 2 Setting Up This chapter describes
Page 23 and 24: Multiple Front-ends Multiple front-
Page 25 and 26: The GP Amp The GP Amp dialog is sim
Page 27 and 28: Mains Filter (/20, /25 and /30 seri
Page 29: Note: variations in the transducer
Page 33 and 34: There are several things to note wh
Page 35 and 36: Setting the Excitation Voltage The
Page 37 and 38: Figure 3-4 The wiring connections f
Page 39 and 40: The Finished Transducer After conne
Page 41 and 42: A A P P E N D I X A Technical Aspec
Page 43 and 44: The output of the amplifier is pass
Page 45 and 46: B A P P E N D I X B Troubleshooting
Page 47 and 48: The BNC or I 2 C cable is faulty.
Page 49 and 50: C A P P E N D I X C Specifications
Page 51 and 52: Index A adapting transducers 31-39

Download - ADInstruments

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?