Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Wisotronic dialog 1-Channel Central
Control Unit EWFS ® This function only makes sense if you have selected a slat product (external
6.2.4 Slat angle after moving
down
venetian blinds or internal venetian blinds) as the product type. After moving
down has been completed by the dawn/dusk control, the slats are turned open to
the set angle. You can ensure that the sunblind is turned either to let the light
through (horizontal, setting 0°) or to protect against viewing from the outside (for
example +80°).
The following figure illustrates the setting of the slat angle:
Positive value: Slats are turned outwards
Negative value: Slats are turned inwards
Setting 0°: The slats remain in a horizontal position
Outside
Inside
+80° 0°
-80°
Fig. 6-6:
Slat angle at external venetian blinds and internal venetian blinds
TIP
The product-typical turning time as well as the producttypical
turning angle (refer to Section 7.2.3 to 7.2.5) have to be
set first.
Note: The setting range of the slat angle depends on the settings made in
Section 7.2.3 to 7.2.5.
■ Change to the dawn/dusk control menu as described above. Turn the function
dial until the following display appears:
Dusk
angle DOWN
80°
— + | }
■ Change the setting values by using the buttons — + and then press the
button |(save). If you want to exit the menu without saving the changes,
press the } button twice consecutively. This completes the process.
34
We reserve the right to carry out improvements
932806A0•816757•7974k0•08.10.2004