Electrolytic Capacitor Product Specification VC TYPE CZ SERIES ...

Electrolytic Capacitor Product Specification
VC TYPE CZ SERIES 4
6. Performance Characteristics
1
Item Performance Characteristics Test
Leakage
Current
2 Capacitance
3
4
Chara
cteristics
at
High and
Low temperature
Tangent of
Loss
Angie
(tan )
5 Surge
Ste
p
2
Ste
p
4
l=0.01CV or 3A whichever is the
greater.
ILeakage current
CNominal Capacitance
VRated voltage
Within the specified capacitance
tolerance
Series Resistor
Applied Voltage
Measuring
1000±100 Ω
Rated voltage
After 2 minutes
Measuring Frequency 120Hz ± 20%
Measuring Circuit Equivalent series circuit
Measuring Voltage 0.5 ~2.0V.DC
(0.5 V for A.C)
Less than the table l value of page 9 Measuring Frequency 120Hz ± 20 %
Impedance Ratio
Less than the table 2 value of page 9
ratio against step 1.
Leakage Current.
500% of the value of item 6.1
Capacitance Change:
Within ±25% of the value in step 1.
Tangent of Loss Angle (tanδ):
the value of item 6.3.
Leakage Current :
the value of item 6.1.
Capacitance Change:
Within±15% of initial measured value.
Tangent of Loss Angle (tanδ ):
the value of item 6.3.
Appearance:
No significant change can be observed.
Measuring Circuit
Measuring Voltage
Equivalent series circuit
0.5 ~2.0V.DC
(0.5 V for A.C )
Step Test Temperature( ) Time
1 20±2
2
Lower category
temperature ±3
30min.
3 20±2 10~15min.
4
Upper category
temperature ±2
30min.
5 20 ± 2 10~15min.
Impedance should be measured 120Hz ± 10%
Test temperature : 15~35
100±50
Series Protective Resistance : C
R: Protective resistance(k)
C: Capacitance(F )
Test voltage : Surge voltage item 3.5
Applied voltage : 1000 cycles of 30±5 sec
'ON and 5 min30sec”OFF “ .
YAGEO ELECTRONIC CORPORATION
Engineering Dept..