current_userManual - Audio Rents
current_userManual - Audio Rents
current_userManual - Audio Rents
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
DMA8Plus Rear Panel<br />
1.2.3 4xAES Input (AES/EBU)<br />
This 25‐pin female D‐connector receives four AES3 streams, which are linked to the digital<br />
1 button. Typically, this input connects to a Dolby Digital cinema server. It accommodates<br />
PCM audio at 96, 48, and 44.1 kHz (16, 20, and 24 bit), Dolby Digital at all data rates and<br />
sample rates, and Dolby E at frame rates of 23.98 (24 pulldown), 24, 25, 29.97, and 30 fps.<br />
The decoding of coded audio (Dolby Digital or Dolby E) is restricted to the first AES3<br />
channel pair. The clocks for all four pairs are derived from pair 1. This connector has a<br />
floating ground.<br />
1.2.4 1xAES Inputs (AES3)<br />
These BNC connectors are linked to the digital 2 and digital 3 buttons respectively. They<br />
accommodate PCM audio at 96, 48, and 44.1 kHz (16‐, 20‐, and 24‐bit), Dolby Digital at all<br />
data rates and sample rates, and Dolby E at frame rates of 23.98 (24 pulldown), 24, 25, 29.97,<br />
and 30 fps. A BNC male to RCA female adapter can interface with most consumer gear.<br />
These connectors have floating grounds.<br />
1.2.5 S/PDIF Optical Input<br />
This Toslink optical connector is linked to the digital 4 button. It accommodates PCM audio<br />
at 96, 48, and 44.1 kHz (16‐, 20‐, and 24‐bit), Dolby Digital at all data rates and sample rates,<br />
and Dolby E at frame rates of 23.98 (24 pulldown), 24, 25, 29.97, and 30 fps.<br />
1.2.6 Digital Media Automation Connector<br />
This interface connects to a theatre automation system. It is a 9‐pin female D‐connector<br />
providing ground‐switching control of the front‐panel input selection buttons. It has a<br />
floating ground. The automation system can switch between film sound (pass‐through)<br />
and any of the four digital media sources. This function duplicates the front‐panel digital<br />
input buttons and the film button. Two pins (6, 7) provide relay dry contact closure<br />
whenever you select either digital 1, digital 2, digital 3, or digital 4 (the relay contacts open<br />
when Film mode is selected) for CP200 digital subwoofer logic control.<br />
1.2.7 RS-232 Serial Port<br />
You can use this port for serial control using ASCII string commands. Set this port to 9600<br />
and 8 1 and use a pin‐to‐pin serial cable. You can also perform the same function using<br />
the Ethernet port, as described in Section 1.2.8.<br />
1.2.8 Ethernet Port<br />
This is an illuminated RJ45 10BASE‐T Ethernet port with activity LEDs, which provides an<br />
interface to a Dolby Digital Cinema network and also ASCII string commands through<br />
telnet protocol to port 61412. You can also use this port for setup software and firmware<br />
upgrades.<br />
Dolby ® DMA8Plus Digital Media Adapter Installation and User’s Manual 5