[MI 019-100] Universal Instruction Manual I/A Series Mass Flow ...

More documents

Recommendations

Info

MI 019-100 – December 2003 2. Installation ♦ ♦ ♦ provide a minimum of 25 mm (1 in) of axial length of surface contact. “Rest type” supports should not be used with sanitary end connections. If your application has excessive vibration that could be transferred to the flowtube sensor, install isolation supports such as those manufactured by Stauff or Behringer. Position valves outside the pipe supports described above. For severe vibration conditions, install two supports on each side of flowtube as shown in Figure 4. FLANGED END CONNECTIONS FLOWTUBE
2. Installation MI 019-100 – December 2003 Figure 5. Recommended Types of Pipe Supports Before installing your flowtube, make sure that ♦ Piping is properly aligned and that the piping ends are parallel with the flowtube ends. ♦ The arrow on the flowtube is pointing in the direction of flow. ♦ The flowtube fits between the connecting piping with 2 to 3 mm (1/8 inch) to spare. It should not be necessary to force the pipes apart to fit the flowtube in place. Then install your flowtube as described below. Threaded End Connections 1. Apply a process compatible thread sealant to the threaded flowtube end connections. 2. Secure the threaded pipe adapters to the flowtube threaded end connections. 3. Secure the pipeline end of the adapters to the pipeline. Flanged End Connections 1. Insert the lower mounting bolts (two for 4-hole flanges, four for 8-hole flanges). 2. Position the gasket between the flanges. 3. Insert the remaining mounting bolts. 4. Add the washers and nuts to all bolts. Hand tighten. 5. Secure the flowtube by tightening the nuts in uniform steps, working from nut to opposite nut. Sanitary Tri-Clamp Quick Disconnect End Connections 1. Insert the seal into the flowtube end connection. 2. Make full face contact between the flowtube end connection and the pipeline end connection. 3. Position the clamp over the mating surfaces of the flowtube end connection and the pipeline end connection and press the clamp closed. 13
Page 1 and 2: Instruction MI 019-100 December 200
Page 3 and 4: Contents Figures...................
Page 5 and 6: Figures 1 Sample CFS10 or CFS20 Mas
Page 7 and 8: Tables 1 Electrical Safety Specific
Page 9 and 10: Preface Standard documentation ship
Page 11 and 12: 1. Safety Information General Warni
Page 13 and 14: 1. Safety Information MI 019-100 -
Page 21: 2. Installation Introduction An Inv
Page 25 and 26: 2. Installation MI 019-100 - Decemb
Page 35 and 36: 3. Start Up CFT50/CFS10 or CFT50/CF
Page 37 and 38: 3. Start Up MI 019-100 - December 2
Page 39 and 40: Index C CFS10 or CFS20 Flowtubes Mo

[MI 019-100] Universal Instruction Manual I/A Series Mass Flow ...

Create successful ePaper yourself

Delete template?

Save as template?