Installation and Start-Up Guide 11/2002 Edition

11.02 Expanding the Operator Interface (BE1)
7 Configuring and Working Environment
LAN1=File
File Language-dependent file which contains the foreground language
(1st language) of all configured texts.
LAN2=File
File Language-dependent file which contains the background language
(2nd language) of all configured texts.
If parameters LAN1/LAN2 are assigned, then the system looks for languagedependent
texts in these files first before searching through the cycle alarm texts.
The contents of the files specified by LAN1/LAN2 matches the format of the alarm
texts (see Section 7.1 General information about configuring environment). File
names can be freely assigned within the scope of the supplementary conditions
stipulated in Section 1.4. The file extension is COM. These text files allow texts to
be created directly in on-line operation which can then be displayed directly in
screen forms created on-line.
CHK_COMMON_COM=ram
ram The control flag: specifies whether a COMMON.COM access
check must be carried out.
Possible values:
0:
A check for the existence of COMMON.COM on the
RAMDRIVE of the MMC, HMI, HT6 is not carried out.
COMMON.COM is read every time it is accessed by the NC.
This setting is selected for test purposes while files are being
set up in order to display any changes immediately.
1:
Check whether COMMON.COM is already stored on the
MMC/HT6 RAMDRIVE. With this setting, files can be
processed faster, but changes do not take effect until the
system is restarted.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D HMI/MMC Installation and Start-Up Guide (IAM) – 11.02 Edition BE1/7-157