Installation and Start-Up Guide 11/2002 Edition

11.02 Starting Up HMI Advanced (IM4)
7 Installation Variants / Data Backup
3. Enter one of the passwords for levels 0-3.
- System
- Manufacturer
- Servicer
- Customer
A warning appears advising caution: "Windows partition E: will be overwritten" and,
following a second prompt, the restoration of partition E: is initiated.
Once the partition E data has been restored, the "Restore finished" message will
appear.
The next time WinNT is booted, partition E: is checked by the test program
CHKDSK.
7.8 SINUMERIK desktop (Windows)
The SINUMERIK desktop is designed to operate as a service mode, which can use
Windows functions to start up the controller.
It is used as the platform for network operation (e.g. for installing HMI system
software), for setting the execution environment of HMI system software or for
accompanying system measures such as authorizing SIMATIC STEP7, hard disk
check, version check, etc.
More detailed information can be found in 3.5, Basic functions of the SINUMERIK
desktop.
7.8.1 Networking
The PCU has one network connection as standard.
Windows NT
Most of the network connection is already
installed on delivery. Once you have
connected the Ethernet cable, you need
only enter the IP address of the PCU or
select use of a DHCP server in order to
set up a TCP/IP communication link.
The entry is made under: Start→Settings
→Control Panel→Network, Protocols tab,
where the TCP/IP protocol properties can
be selected.
By this stage you must have already
specified a unique computer name for the
PCU across the entire network. You can
enter the required name under Start→
Settings→Control Panel→Network,
Identification tab.
Windows XP
Connect the Ethernet cable for
TCP/IP communication.
The default setting is DHCP.
The properties can be modified under
Start→Settings→Network
Connections→Local Area
Connection→Properties.
By this stage you must have already
specified a unique computer name for
the PCU across the entire network.
You can enter the required name
under Start→Settings→Control Panel
→Computer Name tab, Change
button.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D HMI/MMC Installation and Start-Up Guide (IAM) – 11.02 Edition IM4/7-239