Installation and Start-Up Guide 11/2002 Edition

Expanding the Operator Interface (BE1) 11.02
2 First Steps
• The system does not distinguish between upper and lower case type.
• Insertion of a space before or after the equals sign is optional.
• If a command is configured only with a file name, then the file search strategy is
as follows:
Table 2-3
Entry Search in ...
No file name, no path name
File name
File name and path name
File name and NC path name
COM file of current screen form
User cycles directory
Standard cycles directory
(including Flash File System on MMC 100.2)
Specified path
The system looks for the COM file on the
NC, copies it to the MMC and reads it there.
Example
A new screen form is called via access soft key "Example" from the Parameters
operating area.
//S(Start)
HS7=("Example",se1, ac7)
PRESS(HS7)
LM("Form1")
END_PRESS
//END
//M(Form1/"Cycles")
HS1=("")
HS2=("")
HS3=("")
HS4=("")
HS5=("")
HS6=("")
HS7=("")
HS8=("")
VS1=("")
VS2=("")
VS3=("")
VS4=("")
VS5=("")
VS6=("")
VS7=("")
VS8=("")
... ; Methods
//END
BE1/2-24
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D HMI/MMC Installation and Start-Up Guide (IAM) – 11.02 Edition