Installation and Start-Up Guide 11/2002 Edition

11.02 Updates/Supplements (AE1)
5 Changes in SW 6.1/6.2 (10.00) compared to SW 5.3 (04.00)
No. Topic HMI Advanced SW 6.1
(02.01)
Target document(s)
61_56 Conversion of display MDs BAD: Operator's Guide, HMI Advanced, Installation
and Start-Up
IAM/IM4: Start-Up Functions for HMI Advanced
61_57 Accelerated external block search BAD: Operator's Guide, HMI Advanced, Section 4.6
61_58 Multi-channel block search in
program test mode
IAM/IM4: Start-Up Functions for HMI Advanced:
Chapter 5
BAD: Operator's Guide, HMI Advanced, Section 4.6
61_59 Automatic master spindle display BAD: Operator's Guide, HMI Advanced, Section 4.2
61_60 Additional states of skip levels BAD: Operator's Guide, HMI Advanced, Section 4.6
61_61 Rapid traverse override in the
display
BAD: Operator's Guide, HMI Advanced, Section 4.4
61_62 Extended tool parameters FBW: Description of Functions, Tool Management
61_63 Access protection for basic softkey
offset
61_64 Tool management: filtered
lists/order processing
61_65 Tool management: order of
replacement tools
IAM/IM4: Start-Up Functions for HMI Advanced:
Chapter 5
BAD: Operator's Guide, HMI Advanced,
Subsection 5.3.8
FBW: Description of Functions, Tool Management
BAD: Operator's Guide, HMI Advanced, Section 5.3
FBW: Description of Functions, Tool Management
61_66 Simulation: Match data with NC IAM/IM4: Start-Up Functions for HMI Advanced:
Chapter 5
61_67 Change-language softkey,
independent of the language
61_68 NCU-specific alarm texts for
m:n:
BAD: Operator's Guide, HMI Advanced, Section 9.5
IAM/IM4: Start-Up Functions for HMI Advanced:
Section 6.2
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D HMI/MMC Installation and Start-Up Guide (IAM) – 11.02 Edition AE1/5-27