Installation and Start-Up Guide 11/2002 Edition

11.02 Starting Up HMI Embedded (IM2)
11 Installation and Start-up of SINUMERIK HT6
System data display
In the event of a system crash, the crash address, the register allocation and any
additional information needed for crash analysis are displayed on the screen.
Sorry, but HMI Embedded has caused an
exception in task XX with code XXXXX
The exception has occurred in Fct.:
XXXXXXXX at cs : XX eip : XXXXXXXX
DS= XXXX EAX= XXXXXXXX EBX= XXXXXXXX
ES= XXXX ECX= XXXXXXXX EDX= XXXXXXXX
FS= XXXX EDI= XXXXXXXX ESI= XXXXXXXX
GS= XXXX FLAGS= XXXXXXXX
SS= XXXX ESP= XXXXXXXX EBP= XXXXXXXX
Please send the screen information or
saved data to the SINUMERIK Hotline!
email : ad.support@siemens.com
Fill in subject :
"HMI Emb exception (SW XX.XX.XX;date)"
Press '1' to save data
Press other key for next page
When you select key
"1", you go to the menu for saving the data;
with any other key, you go to the next screen.
Additional information :
XXXXXXXX:XXXXXXXX XXXXXXXX:XXXXXXXX
...
XXXXXXXX:XXXXXXXX
CODE = XX XX XX XX XX XX XX XX XX XX
EIP: XX XX XX XX XX XX XX XX XX XX
STACK= XXXXXXXX XXXXXXXX XXXXXXXX
XXXXXXXX XXXXXXXX XXXXXXXX
XXXXXXXX XXXXXXXX XXXXXXXX
Press '1' to save data or press '9' to
reboot immediately
When you select key
"1", you go to the menu for saving the data;
key "9" reboots the HT 6.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D HMI/MMC Installation and Start-Up Guide (IAM) – 11.02 Edition IM2/11-207