Installation and Start-Up Guide 11/2002 Edition

Starting Up HMI Advanced (IM4) 11.02
5 Functions / Parameterization
9661 CMM_ENABLE_CUSTOMER_M_CODES QV: FBSP
Input of customer-specific M functions
This MD is used to enable the number of input fields for customer-specific M functions:
0 = No display fields for customer-specific M functions
1 = 1 field for one customer-specific M function is displayed
2 = 2 fields for two customer-specific M functions are displayed
3 = 3 fields for two customer-specific M functions are displayed
4 = 4 fields for two customer-specific M functions are displayed
4 0 4
9663 CMM_TOOL_DISPLAY_IN_DIAM QV: FBSP,
FBT
Radius/diameter display for tool
This MD is used to specify how the tool should be displayed/entered:
0 = Radius
1 = Diameter
1 0 1
9672 CMM_FIXED_TOOL_PLACE QV : FBSP,
FBT
Fixed tool location coding
This machine data is used to define the status of the tools:
0 = Tools with variable tool location coding in magazine
1 = Tools with fixed tool location coding in magazine
Note for ST: On a turret, tools are always assigned a fixed location,
i.e. the MD must be set to "1".
Remark: If MD 9014: USE_CHANNEL_DISPLAY_DATA is set appropriately, MD 9672
can be managed on a channel-specific basis in the NC.
9673 CMM_TOOL_LOAD_STATION QV: FBSP,
FBT
Load station number
This machine data can be used to define the load station via which the magazine
is loaded and unloaded.
1 = Load station 1
2 = Load station 2
Remark: If MD 9014: USE_CHANNEL_DISPLAY_DATA is set appropriately, MD 9673
can be managed on a channel-specific basis in the NC.
- 1 1 2
9674 CMM_ENABLE_TOOL_MAGAZINE QV: FBSP,
FBT
- Display magazine list
0 = Magazine list is not displayed
1 = Magazine list is displayed
1 0 1
IM4/5-134
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D HMI/MMC Installation and Start-Up Guide (IAM) – 11.02 Edition