PROFIBUS-DP OPTION OPC-G11S-PDP for ... - Fuji Electric America

Bit 2, OFF3/ON3:
Bit=0: Fast stop that uses deceleration time specified in DEC TIME4 (Enter OFF3 active state). When output
frequency = 0 the drive output is disabled.
Bit=1: Drive can be started if all other start conditions are fulfilled.
Bit 3, Operation disabled/enabled
Bit=0: Drive coast to stop (Enter Inhibit operation state).
Bit=1: Drive can be started if all other start conditions are fulfilled.
Bit 4, Ramp generator disabled/ Condition for operation
Bit=0: Output frequency is set to 0. Inverter remains in Running state.
Bit=1: Drive can be started if all other start conditions are fulfilled.
Bit 5, Stop ramp generator/ Ramp generator enabled
Bit=0: Actual output frequency is frozen. Changes to frequency setpoint has no affect.
Bit=1: Drive can be started if all other start conditions are fulfilled.
Bit 6, Setpoint disabled/enabled
Bit=0: Normal stop that uses deceleration time specified in DEC TIME1.
Bit=1: Drive can be started if all other start conditions are fulfilled.
Bit 7, No function/ Fault acknowledge
Bit=0: No fault acknowledge.
Bit=1: Fault is acknowledged on positive edge, i.e. bit = 0 then 1 (Enter Switch-on inhibit state).
Bit 10, Data invalid/ Data valid
Bit=0: The control word and frequency setpoint (from PROFIBUS) are not activated.
Bit=1: The control word and frequency setpoint (from PROFIBUS) are activated.
Bit 11, No function/Reversing
Bit=0: Drive is not reversing.
Bit=1: Drive is reversing.
USER MANUAL
Revision 0.14
2000-01-14
HMS FIELDBUS SYSTEMS AB 24