Installation and Operation Manual For Hunter Ceiling ... - Hunter Fan
Installation and Operation Manual For Hunter Ceiling ... - Hunter Fan
Installation and Operation Manual For Hunter Ceiling ... - Hunter Fan
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
®<br />
STEP 3 - ASSEMBLING PIPE/BALL ASSEMBLY<br />
As discussed in STEP 1 - GETTING<br />
READY, your <strong>Hunter</strong> fan can be installed<br />
in a st<strong>and</strong>ard mounting position.<br />
Included with the fan are two pipes:<br />
one 3" long pipe/ball assembly for<br />
st<strong>and</strong>ard mounting on 8' ceilings <strong>and</strong><br />
one 12" long pipe for 9' ceilings <strong>and</strong><br />
higher. See Figure 3a.<br />
If you are going to install the fan using<br />
the st<strong>and</strong>ard mounting, go to<br />
STEP 4 - ASSEMBLING THE FAN.<br />
If you are going to install the fan using<br />
the 12" long pipe for 9' ceilings<br />
or higher, complete the steps below.<br />
12" Pipe<br />
3" Pipe/Ball<br />
Assembly<br />
Figure 3a - Pipes<br />
REMOVING BALL ASSEMBLY<br />
<strong>For</strong> the following steps refer to<br />
Figures 3b <strong>and</strong> 3c.<br />
1. Locate the 3" pipe/ball assembly.<br />
2. Remove the positioning screw<br />
from the top of the ball.<br />
NOTE: The ball will become<br />
loose <strong>and</strong> should slide down the<br />
pipe.<br />
3. Remove the ball from the pipe.<br />
4. Remove the pin from the pipe.<br />
Leadwire<br />
Assembly<br />
Ground<br />
Screw<br />
Positioning Screw<br />
Pin<br />
Ball<br />
Figure 3b - Removing ball assembly<br />
continued<br />
10<br />
41457-01 7/2000