Introduction to LabVIEW Control Design Toolkit by Finn Haugen ...

3.8 Getting information about a model
You can get various information about a model by using functions on the Create Model /
Model Information subpalette.
Example 3.8.1: Getting the numerator and denominator coeffiecient arrays of a transfer function
model
The VI shown below shows how to get the numerator and denominator coeffiecient arrays of a
transfer function model using the CD Get Data from Model function.
End of Example
Front panel and block diagram of get_model_data.vi.
3.9 Converting Control Design models to/from Simulation Module models
You can use models created in Control Design Toolkit in a Simulation diagram in the LabVIEW
Simulation Module. However, it is then necessary to first convert the model by using the CD
Convert Control Design to Simulation function.
Example 3.9.1: Converting a Control Design Toolkit model to a Simulation Module model
The VI shown below shows how to convert a transfer function model.
End of Example
Front panel and block diagram of convert_to_simmodule.vi.
4 Connecting models
The Model Interconnection palette contains several functions for connecting models. Series
connection and a feedback connection of transfer functions are described in the following.