Knee Retractor - Innomed, Inc.

Trans-sulcus Angle Guide
Helps establish the trans-sulcus line
PRODUCT NO:
1160
Dimensions: 2.25" x .75"
Post Depth: 1.5"
PROUDLY
MADE
IN THE USA
Line is drawn
along bottom of guide
A line is drawn down the deepest part of the trochlear sulcus (Whiteside
line) with a marking pen or cautery. The post on the guide is inserted into
the hole in the femur made for an intramedullary alignment guide. The
trans-sulcus angle guide is then rotated until the line on the guide lines up
with the Whiteside line. A line is then drawn along the bottom of the guide.
Shown
at Actual
Size
Sorrells Tibia Protector Plates
Designed by R. Barry Sorrells, MD
Designed to protect
the surface of the tibia
PRODUCT NO’S:
1130 [Large] 75mm x 45mm
1135 [Small] 65mm x 40mm
PROUDLY
MADE
IN THE USA
Femoral Trial Extraction Hook
Designed to help remove a trial femoral
component during total knee arthroplasty
PRODUCT NO’S:
3635 [Hook with Slap Hammer]
3635-01 [Hook Only]
Overall Length: 2.85"
Hook End: 5mm X 5mm
3040 [Slap Hammer]
Overall Length: 6.75" – 10"
PROUDLY
MADE
IN THE USA
KNEE PRIMARY & REVISION INSTRUMENTS I 1.800.548.2362 I FREE TRIAL ON MOST INSTRUMENTS
35