Mitel Technical Specification 22
Mitel Technical Specification 22
Mitel Technical Specification 22
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MiNET <strong>Specification</strong><br />
4 Messages common to all terminals<br />
In the message descriptions following, the MT (Message Type) code values are presented as hexadecimal<br />
values, and are shown in brackets following the message title.<br />
4.1 Allocated messages<br />
Table 3/MTS<strong>22</strong>-C lists all messages defined within the common allocation block.<br />
MT<br />
C0<br />
C1<br />
C2<br />
C3<br />
C4<br />
C5<br />
C6<br />
C7<br />
C8<br />
C9<br />
CA<br />
CB<br />
CC<br />
CD<br />
CE<br />
CF<br />
D0<br />
D1<br />
D2<br />
D3<br />
D4<br />
D5<br />
D6<br />
D7<br />
D8<br />
D9<br />
DA<br />
DB<br />
DC<br />
to<br />
FE<br />
FF<br />
Message<br />
Table 3/MTS<strong>22</strong>-C<br />
Common block message allocation<br />
Request Set ID<br />
Report Set ID<br />
Network Level Message Reject<br />
Read Set Memory<br />
Report Set Memory<br />
Request Maintenance Data<br />
Send Maintenance Data<br />
Request Set Reset<br />
Load Address<br />
Load Data<br />
Variable Length Load Data<br />
Checksum Request<br />
Checksum Reply<br />
Run<br />
Write Set Memory<br />
Define Channel and MiLINK Parameters<br />
Configure Hardware<br />
Report Channel and MiLINK Parameters<br />
Datagram<br />
Local Programmable Key Control<br />
Miscellaneous Indicator Control<br />
Set Relay<br />
Pager Module Ringing<br />
Report Config Change<br />
Send Set Serial Number<br />
PIN Reply<br />
PIN Request<br />
Set Lockup Request<br />
Reserved<br />
Extension code<br />
4.2 Message descriptions<br />
4.2.1 Commands from system to terminal<br />
4.2.11 Request Set ID (C0)<br />
The format of this command shall be as shown in Figure 4/MTS<strong>22</strong>-C.<br />
This command shall be used by the system to determine the identity of attached terminals. The terminal<br />
shall reply with a Report Set ID response (see § 4.2.2.1).<br />
Note -<br />
This command is generally sent as the result of a system reset.<br />
<strong>Mitel</strong> Restricted MTS<strong>22</strong> (Version B05) 3:12 PM 30/12/10Page 18 of 173