Mitel Technical Specification 22

MiNET Specification
2C Initialize Display Not used
2D Select Stored Prompt Not used
2E Define 5 x 7 Special Character Not used
2F Not used Not used
30 Define Character Pattern Not used
31 Not used Not used
32 Not used Not used
33 Setup Not used
34 Start New Call Tone Not used
35 Wireless Not used
36 Map Character To Unicode Not used
37-4E Not used Not used
50 Go To URL Not used
51 Send Directory Number Not used
52 Send Label String Not used
53-7D Not used Not used
7E Keepalive Poll Link Layer Ack
5.2 Message descriptions
5.2.1 Commands from system to terminal
5.2.1.1 General format and definitions of elements
The general format for messages within the voice sets and consoles allocation block in the direction system
to terminal shall be as shown in Figure 33/MTS22-C.
MT Octet 1
SAB
INFORMATION
Octet 2
Octet 3
INFORMATION Octet n+2
Figure 33/MTS22-C
Voice sets and consoles general command
Note - The value of n is a function of the specific message type. Refer to the detailed descriptions
following.
The SAB (Special Attribute Byte) octet can have the following types:
1) BCCB = Buffer / Cursor Control Byte
2) SBDB = Source Buffer / Destination Buffer
3) NPBN = Number of Prompts / Buffer Number
4) PPBN = Prompt Position / Buffer Number
5) CRSR = Circle Rate / Square Rate
6) CSRN = Circle / Square Rate Number
7) HCB = Hardware Control Byte
8) CPB = Cadence Pattern Byte
Note -
Not all commands require a SAB octet.
Detailed definitions of the above SAB octet types are given in §§ 5.2.1.1.1 to 5.2.1.1.8.
5.2.1.1.1Buffer / Cursor Control Byte (BCCB)
Mitel Restricted MTS22 (Version B05) 3:12 PM 30/12/10Page 40 of 173