Mitel Technical Specification 22
Mitel Technical Specification 22
Mitel Technical Specification 22
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MiNET <strong>Specification</strong><br />
Define Channel And MiLINK Parameters command format<br />
The CHMB (Channel and MiLINK octet) octet is defined as follows:<br />
b8 = MiLINK lock control<br />
0 no change<br />
1 unlock MiLINK<br />
b7 b6= B channel assignment<br />
0 0 no change<br />
0 1 use B1 for primary<br />
1 0 use B2 for primary<br />
1 1 release B1 and B2 channels<br />
b5 b4 b3 b2 b1 = MiLINK data link layer address allocation<br />
0 0 0 0 0 no change<br />
0 0 0 0 1 reserved for data sets<br />
0 0 0 1 0 available<br />
to<br />
1 1 1 1 0 available<br />
1 1 1 1 1 reserved for address negotiation (see MTS21 [10])<br />
Note- See § 3.3/MTS21 for the format of address allocation.<br />
4.2.1.7Configure Hardware (D0)<br />
The format of this command shall be as shown in Figure 10/MTS<strong>22</strong>-C.<br />
This command shall be used by the system to initialize and/or control any allowable hardware parameter or<br />
feature within a<br />
peripheral.<br />
MT Octet 1<br />
DEV<br />
ACT<br />
LEN (optional)<br />
STREAM (optional)<br />
Octet 2<br />
Octet 3<br />
Octet 4<br />
Octet 5<br />
STREAM (optional)<br />
Octet LEN+4<br />
Figure 10/MTS<strong>22</strong>-C<br />
Configure Hardware command format<br />
The LEN (Length) octet, when used, shall specify the length of the STREAM field in octets. Valid values<br />
for LEN shall fall within the range 0 to 255 (decimal). The LEN field shall not be used when the value of<br />
ACT is 5 (disable) or 6 (return to default).<br />
The STREAM field, when used, is dependent on the value of the DEV and ACT octets. The STREAM field<br />
shall not be used when the value of ACT is 5 or 6.<br />
The DEV (Device) octet specifies the device type to be acted upon, and is defined as follows:<br />
00 = hard reset of phone (if act == 6)<br />
01 = volume keys<br />
02 = CODEC law and format control<br />
03 = flashhook timing<br />
04 = unused<br />
05 = ringing frequency and level<br />
06 = filter coefficients<br />
07 = HC11 flash (memory device)<br />
08 = Mantis flash (memory device)<br />
<strong>Mitel</strong> Restricted MTS<strong>22</strong> (Version B05) 3:12 PM 30/12/10Page <strong>22</strong> of 173