SILENT KNIGHT MODEL 5207

More documents

Recommendations

Info

Compatible Product Installation 4.9.2 5230 Permanent Connection Wire permanent 5230s as shown in Figure 4-10. When the annunciator powers up, it will display its ID code and current status of the panel. A temporary 5230 can be connected for programming and troubleshooting. See Section 4.9.4 for temporary annunciator connection. Figure 4-10 Model 5230 Connection 150865 4-11
Model <strong>5207</strong> Installation and Operation Manual 4.9.3 Mounting the 5230 Remote Annunciator For UL installations, the 5230 Remote Annunciators must be mounted on a dual gang electrical box and all wiring runs must be made using 18-gauge wire or larger. To mount the annunciator: 1. Remove the rear mounting plate by inserting a #4 flat blade screwdriver into the slots on the bottom edge of the annunciator. Gently turn the screwdriver until the mounting plate pulls away from the frame. 2. Secure it to the wall using #6 or #8 screws. The mounting plate should be oriented so that the word TOP is toward the top of the plate and facing you. A square hole is provided in the mounting plate to run the wiring to the annunciator. 3. When all of the wires have been connected to the annunciator, set the top of the annunciator over the tabs on the top of the mounting plate. Make sure the wires do not get pinched between the frame and the mounting plate. Press each corner of the bottom side onto the annunciator mounting plate until you hear it click. You may have to gently squeeze the annunciator (top to bottom) to align it while snapping the bottom edge into place. 4.9.4 Temporary Annunciator Connection If you are using an annunciator for programming or troubleshooting only, you can use cable P/N 130294 (ordered separately) to temporarily attach the 5230 at connector P3. Figure 4-11 shows the connections. A temporary annunciator must have an ID number (1 or higher) but does not need to be enabled through programming. Figure 4-11 Temporary Annunciator Connection 4-12 150865
Page 1 and 2: SILENT KNIGHT MODEL 5207 Fire Contr
Page 3 and 4: Model 5207 Fire Control/Communicato
Page 27 and 28: Model 5207 Installation and Operati
Page 35: Model 5207 Installation and Operati
Page 87 and 88:
Model 5207 Fire Control/Communicato
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
show all

SILENT KNIGHT MODEL 5207

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?