ELECTRONIC THREE-SPEED AUTOMATIC WASHERS with ...

More documents

Recommendations

Info

QUIET PAK The QUIET PAK System is designed to reduce water sounds and mechanical noises. The cabinet and base are insulated <strong>with</strong> sound-dampening materials over which an additional tub wrap is added for superior vibration and sound-dampening characteristics. RING GUARD SOUND ABSORBING TUB WRAP The bleach venturi causes a siphoning action to draw bleach from the bleach dispenser. Water passing across the venturi opening creates a low pressure area behind the venturi pulling the bleach into the passing water flow. BLEACH VENTURI TUB RING Bleach/Fresh Water Mixture Inlet Fresh Water Inlet Catalyst Cleaning Action Spray Inlet Fabric Softener Mixture Inlet Detergent/ Fresh Water Mixture Inlet 2
PRESSURE TRANSDUCER TRANSDUCER HARNESS PLUGS The water level transducer is located at the left end of the console area and is used to regulate the level of wash and rinse water in the tub. The electronic pressure transducer converts air pressure created in the pressure dome to a low voltage square wave signal. The microcomputer on the control board reads the signal directly. The microcomputer then translates the frequency into inches of water. This is then compared to the setting selected by the user during the wash cycle. The transducer also contains a mechanical overfill switch in the same transducer body. This operates the same as the standard pressure switch. The overfill operates (opens) when the water level in the tub is beyond the standard high fill level (flood level). The Out of Balance Switch controls the motor operation during the Catalyst Cleaning portion of the cycle, as well as during the spin. If an out of balance condition occurs during Catalyst Clean, the motor circuit is interrupted. The motor will stop momentarily to allow the load to settle, then restart. If the Out of Balance Switch is actuated four times, the Electronic Control will skip the Catalyst Clean cycle and jump to the wash increment. If an out of balance condition occurs during spin, the motor circuit will again be interrupted momentarily to allow the load to settle. If the Out of Balance switch is actuated four times during the spin cycle, the cycle will stop and the control will display “OB”. OUT OF BALANCE SWITCH 3
Page 1 and 2: CONSUMER SERVICES TECHNICAL EDUCATI
Page 3 and 4: TABLE OF CONTENTS SAFETY ..........
Page 5: Section One FEATURES Catalyst Clean
Page 9 and 10: DISPENSERS Bleach Dispenser Fabric
Page 11 and 12: Section Two THEORY OF OPERATION CON
Page 13 and 14: Choosing Options Use the OPTIONS co
Page 15 and 16: Operating Controls Press the START
Page 17 and 18: AGITATE SPEEDS CYCLES HEAVY DUTY NO
Page 19 and 20: Section Three COMPONENT ACCESS COMP
Page 21 and 22: 3. To remove the Electronic Control
Page 23 and 24: NOTE:If the washer must be operated
Page 25 and 26: BLEACH DISPENSER OUTLET VALVE (with
Page 27 and 28: RECIRCULATION PRESSURE SWITCH RECIR
Page 29 and 30: Section Four COMPONENT TESTING AND
Page 31 and 32: DISPLAY F F (Fill Failure) L F (Lon
Page 33 and 34: 2. If the resistance is outside of
Page 35 and 36: 4. Beeps are NOT heard If beeps are
Page 37 and 38: Test #7 - Water Level Transducer Te
Page 39 and 40: Section Five TECH TIPS WIRING DIAGR
Page 41 and 42: -- NOTES -- 37
Page 43 and 44: PRODUCT SPECIFICATIONS AND WARRANTY

ELECTRONIC THREE-SPEED AUTOMATIC WASHERS with ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?