tandem vector owner's manual
tandem vector owner's manual
tandem vector owner's manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SIGMA TANDEM SYSTEM OWNER’S MANUAL<br />
Thread the pull-up cord through the bottom<br />
kicker flap (flap #1). If equipped with a Cypres be<br />
sure to pass through the cutter before passing<br />
through flap #1.<br />
You may evaluate the length of your closing<br />
loop by the following method: Press the #1 flap<br />
firmly down while pulling with adequate force<br />
on the pull-up cord. The top of the closing loop<br />
should extend beyond the bound edge of flap<br />
#1 by a 1/4" to 1/2". This will help ensure the<br />
proper length closing loop is being used. Secure<br />
flap #1 with temp pin.<br />
Fold the bridle vertically along both sides of the<br />
center grommet and place these folds under<br />
flap #1. Leave approximately 5' of bridle<br />
unstowed below the pilot chute.<br />
11301 - 00.00.0000 Section 2: Equipment • Chapter 3 - Packing the Reserve w/ Skyhook<br />
Page 21:X