MAX II Development Kit Getting Started User Guide

More documents

Recommendations

Info

Features ■ Reference Designs/Demos—Altera provides several demos and reference designs with the MAX II Development Kit to help you get started building applications. See “Demo Designs” on page 2–7 and “Reference Designs” on page 2–16 for more information on the designs provided. 1–2 Development Kit Version 1.0.0 Altera Corporation MAX II Development Kit Getting Started User Guide October 2004
Chapter 2. Getting Started System Requirements Before using the kit or installing the software, be sure to check the contents of the kit and inspect the board to verify that you received all of the items. If any of these items are missing, contact Altera ® before you proceed. You should also verify that your PC meets the software and system requirements of the kit. MAX II Development Kit Contents The MAX ® II Development Kit contains the following items: ■ ■ ■ ■ ■ MAX II development board with an EPM1270 device ByteBlaster II Programming cable USB Type A-B cable MAX II Development Kit CD-ROM Quartus ® II Development Software Web Edition CD-ROM Inspect the Board 1 The MAX II development board can be damaged without proper anti-static handling. Place the board on an anti-static surface and inspect it to ensure that it has not been damaged during shipment. Verify that all components are on the board and appear intact. Note that some components are purposefully unpopulated. There are several resistors that are unpopulated, as well as an EEPROM socket (J10). f Refer to the MAX II EPM1270 Development Board Data Sheet (available on the MAX II Development Kit CD-ROM) for information on the board components and their locations. Software Requirements You should install the following software before you begin developing designs for the kit: ■ Internet Explorer 4.01 with Service Pack 2 or later to use Quartus II Help. You need a web browser to register the Quartus II software and request license files. Altera Corporation Development Kit Version 1.0.0 2–1 October 2004 MAX II Development Kit Getting Started User Guide
Page 1 and 2: MAX II Development Kit Getting Star
Page 3 and 4: Contents About this User Guide Revi
Page 5 and 6: About this User Guide Revision Hist
Page 7: Chapter 1. About this Kit The MAX
Page 11 and 12: Getting Started Figure 2-1. MAX II
Page 13 and 14: Getting Started Set Up the MAX II D
Page 15 and 16: Getting Started d. Pressing S2 a fo
Page 17 and 18: Getting Started Figure 2-3. Active
Page 19 and 20: Getting Started V_INT shows the Cor
Page 21 and 22: Getting Started then the power. Sim
Page 23 and 24: Getting Started Figure 2-5. Program
Page 25 and 26: Getting Started Using the USB Refer
Page 27 and 28: Getting Started Figure 2-7. Device
Page 29 and 30: Getting Started e. Read the UFM—T
Page 31 and 32: Getting Started repeatedly pressing
Page 33 and 34: Getting Started ■ ■ ■ Start-u
Page 35 and 36: Getting Started c. Type the followi
Page 37 and 38: Getting Started 11. Push one of the

MAX II Development Kit Getting Started User Guide

Create successful ePaper yourself

Delete template?

Save as template?