Download [PDF] - InventorCAM

MULTI-SIDED MACHINING
The multi_sided_machining_1_IV.prz example illustrates the use of
InventorCAM Multi-sided machining to machine the manifold plate shown
above, using a 5-axis CNC Machine. The initial stock for this example comes
from casting.
The following InventorCAM operations are created to perform the machining:
• Top face machining (FM_profile)
This Face Milling operation performs the machining of the top
face of the cover. An end mill of Ø16 is used. The machining
is performed in two passes - rough and finish. A machining
allowance of 0.2 mm remain unmachined at the floor after the
rough pass and removed during the finishing pass. Position #1 of
the Machine Coordinate system is used for the operation.
• Front hole machining (D_drill; F_profile_1)
These operations are used for the front hole machining using
Position #2 of the Machine Coordinate system. The Drill operations
perform center-drilling and two steps drilling of the hole. The
Profile operation is used for the machining of the connector faces
around the hole.
26
InventorCAM + Inventor = The Complete Integrated Manufacturing Solution